Small Frog Li-ion Battery 24V 5ah for E-Bike/Motorcycle Battery

Small Frog Li-ion battery 36V 10ah for e-bike/motorcycle battery

Product specifica t ion

Cell

model

GLM5Ah-7268124

Capacity(0.5C)

≥5Ah

rated voltage(V)

3.7V

Typical Impedance (mΩ)

≤12mΩ

Battery material

NMC cathode material

PACK

Combination method

2P7S

Minimal capacity(0.5C)

10Ah

Nominal voltage

24V

Max. charge voltage

29.4V

Discharge cut-off voltage

≤21V

Max Charge current

5A

Max Working current

15A

Standard charge current

0.2C

Standard charge current

0.5C

Pack Impedance standard

≤100mΩ

Weight (Approx.)

2.5Kg

Max. dimension(LxWxH)(mm)

90*150*255

Operatingtemperature

Chargetemperature

0ºC~45ºC

Dischargetemperature

-10ºC~55ºC

BMS

Single cell over-charge cut-off voltage

4.2V

over-chargereleasevoltage

4.1V

Single cell under-dischargecut-offvoltage

2.75V

Dischargereleasevoltage

3.0V

Over-discharge cut-off current

52A

Over-discharge cut-off current delay

1.5S

Short-circuit protection

150A

Short-circuit protection delay

500uS

Condition for the recovery ofover-current andShort-circuit

Balance current

40-50mA

Balance Condition

4.175

Caution:

1.Do not dismantle,open or shredthebatteries.

2.Do not expose batteries to heat or fire.Avoid storage in direct sun light.

3.Do not short-circuitthebattery,Do not store batteries haphazardly in a boxor drawer where they maybe short-circuited by other metalobjects.

4Forbid confusedly using the charge socket and discharge socket,oraccidentsmayoccurred.

5.Do not subject batteries to mechanical shock.

6.In the event of a cell leaking,do not allow the liquidtocome in contact with the skin oreyes.If contact has been made,wash the affected area with copious amounts of waterand seek medical advice.

7.Observe the plus (+) and minus (-) marks on thebattery and equipment and ensurecorrect use.

8.Keep batteries out of the reach of children.

9.Keep batteries clean and dry.

10.Wipe the battery terminal s with a clean dry cloth if they become dirty.

11.Batteries need to be charged before use.Always use the correctcharger and refer to the manufacturer's instructions or equipment manual for propercharging instructions.

12.Do not leave a battery on prolonged charge when not in use.

13.After extended periods of storage,itisnecessary to charge and discharge the batteries several times to obtain maximum performance.

14.The batteries give their best performance when they are operated atnormal room temperature (20 °C ± 5 °C).

15.Retain the original product literature for future reference.

16.Use only thebattery in the application for which it was intended.

17When possible,remove the battery from the equipment when not in use.

18.Dispose of properly.

19.Cells used as E-motor or storage power should be matched with controller or related equipment..Becausethe battery piles are matched with protection board,you can not drive the pure inductanceequipmentotherwise you could damage the whole system.