36V 10ah Power Lithium Battery LiFePO4 for E-Bike

Battery group specifications

Cell

model

GLP10Ah-7768256

Capacity(0.5C)

≥10Ah

rated voltage(V)

3.2V

Typical Impedance (mΩ)

≤5mΩ

Battery material

NMC cathode material

PACK

Combination method

1P12S

Minimal capacity(0.5C)

10Ah

Nominal voltage

36V

Max. charge voltage

43.8V

Discharge cut-off voltage

≤30V

Max Charge current

5A(0.5C)

Max Working current

15A(1.5C)

Standard charge current

0.3C

Standard charge current

0.5C

Pack Impedance standard

≤100mΩ

Weight (Approx.)

4.2Kg

Max. dimension(LxWxH)(mm)

76*107*380

Operatingtemperature

Chargetemperature

0ºC~45ºC

Dischargetemperature

-20ºC~60ºC

BMS

Single cell over-charge cut-off voltage

3.7V

over-chargereleasevoltage

3.6V

Single cell under-dischargecut-offvoltage

2.5V

Dischargereleasevoltage

2.7V

Over-discharge cut-off current

40A

Over-discharge cut-off current delay

1.5S

Short-circuit protection

100A

Short-circuit protection delay

500uS

Condition for the recovery ofover-current andShort-circuit

Balance current

40-50mA

Balance Condition

3.6

Caution:

1.Do not dismantle,open or shredthebatteries.

2.Do not expose batteries to heat or fire.Avoid storage in direct sun light.

3.Do not short-circuitthebattery,Do not store batteries haphazardly in a boxor drawer where they maybe short-circuited by other metalobjects.

4Forbid confusedly using the charge socket and discharge socket,oraccidentsmayoccurred.

5.Do not subject batteries to mechanical shock.

6.In the event of a cell leaking,do not allow the liquidtocome in contact with the skin oreyes.If contact has been made,wash the affected area with copious amounts of waterand seek medical advice.

7.Observe the plus (+) and minus (-) marks on thebattery and equipment and ensurecorrect use.

8.Keep batteries out of the reach of children.

9.Keep batteries clean and dry.

10.Wipe the battery terminal s with a clean dry cloth if they become dirty.

11.Batteries need to be charged before use.Always use the correctcharger and refer to the manufacturer's instructions or equipment manual for propercharging instructions.

12.Do not leave a battery on prolonged charge when not in use.

13.After extended periods of storage,itisnecessary to charge and discharge the batteries several times to obtain maximum performance.

14.The batteries give their best performance when they are operated atnormal room temperature (20 °C ± 5 °C).

15.Retain the original product literature for future reference.

16.Use only thebattery in the application for which it was intended.

17When possible,remove the battery from the equipment when not in use.

18.Dispose of properly.

19.Cells used as E-motor or storage power should be matched with controller or related equipment..Becausethe battery piles are matched with protection board,you can not drive the pure inductanceequipmentotherwise you could damage the whole system.