ISO SGS Industrial Large Span Steel Structure Warehouse

ISO SGS Industrial Large Span Steel Structure Warehouse1. Item Advantages
ISO SGS Industrial Large Span Steel Structure Warehouse
a. High Strength The high strength of steel per unit of weight means that structure weights will be small. This
fact is of great importance for long-span bridges, tall buildings, and structures having poor foundation conditions.b. Uniformity The properties of steel do not change appreciably with time as do those of reinforced concrete structure.c. Elasticity Steel behaves closer to design assumptions than most materials because it follows Hooke's law up to fairly high stresses. The moments of inertia of asteel structure can be definitely calculated while the value obtained for areinforced concrete structure are rather indefinite.d. Permanence Steel frames Prefab Steel Workshop that are properly maintained will last indefinitely. Research on some of the newer steels indicates that under certain conditions no painting maintenance whatsoever will be required.e. Ductility The property Prefab Steel Workshop of amaterial by which it can withstand extensive deformation without failure under high tensile stresses is said to be its ductility. When amild or low-carbon structural steel member is being tested in tension ,a considerable reduction in cross section and alarge amount elongation will occur at the point of failure before the actual fracture occurs. Amaterial that does not have this property is generally unacceptable and is probably hard and brittle and might break if subjected to asudden shock .II, Pictures Show
III, Parameter &SpecificatioParametersNameIndustrial Steel Building DesignBrandClassic GroupAnti-fire GradeB1Anti-earthquake GradeAs per your requestsWind Load0.6kn/m2Live Load0.5kn/m2Dead Load0.3kn/m2Service LifeWithin 50 yearsOther PerformanceAnti-static, Anti-moist, strong enough and easily assemble
MAIN STEEL PART of Steel Workshop
1. Hsection steel columns, beams and wind-proof columns
2. With treatment of one time red-oxide primer painting and two times grey facing painting
SEConDARY STEEL PART of Steel Structure Warehouse
1. Roof &Wall C/Z Purlin
2. Tie Bar: φ89*3.0
3. Roof Support &Support between Columns: φ20
4. Bracing Bar: φ12
5. Knee Bracing: Angle Steel
ROOF &WALL CLADDING
1. Roof &Wall Corrugated Single Steel Sheet: 0.3mm-0.6mm
2. Roof &Wall Sandwich Panel Insulated with EPS Foam, Glass wool, Rock wool and PU: 50mm-150mm
3. Transparent Sheet (FRP): 1.0mm-2.0mm
4. Flashings: Made by Color-coated Corrugated Steel Sheet
WINDOW &DOOR
1. Window: PVC Window or Aluminum-alloy Window
2. Door: Sliding Door or Roll-up Door
FASTENERS
High-strength Bolt; Common Bolt and Nut; Self-tapping Screws; Foundation Bolt and Nut, ETC1Location (where will be built?)_____country, area2Size: length*width*height_____mm*_____mm*_____mm3wind load (max. wind speed)_____kn/m2, _____km/h, _____m/s4snow load (max. snow height)_____kn/m2, _____mm5anti-earthquake_____level6brickwall needed or notIf yes, 1.2m high or 1.5m high7thermal insulationIf yes, EPS, fiberglass wool, rockwool, PU sandwich panels will be suggested; .if not, the metal steel sheets will be ok. The cost of the latter will be much
lower than that of the former8door quantity &size_____units, _____(width)mm*_____(height)mm9window quanity &size_____units, _____(width)mm*_____(height)mm10crane needed or notIf yes, _____units, max. lifting weight____tons; max. lifting height _____m
IV. about Us
V, Contact me