China GPS Module Antenna GPS Engine Module Antenna Antenna with Mediatek Mt3339 Chip Set

GeneralDescription TheDelinSensor DL-1616N-GCMFisacomplete GPS engine module that features super sensitivity, ultra low powerand small form factor.The GPS signal is applied to the antennainput of module, and a completeserialdatamessagewithposition ,velocityandtimeinformationispresentedattheserial interfacewithNMEAprotocol orcustom protocol. Its-165dBmtrackingsensitivityextendspositioning coverage intoHydraulic Parts place like urban canyonsanddensefoliageenvironmentwhere theGPSwas notpossiblebefore.The small form factor and low power consumption make the moduleeasy to integrate intoportable device like PNDs, mobile phones, cameras and vehicle navigation systems.ApplicationsLBS (Location based Service)PND (Portable Navigation Device)Vehicle navigation systemMobile phoneFeaturesBuild on high performance, low-power MediaTek MT3339chip setUltra high Track sensitivity: -165dBmExtremely fastTTFFat low signal levelBuilt in high gain LNALow power consumption: Max 28mA@3.3VNMEA-0183 compliant protocol or custom protocolOperating voltage: 2.8V to 4.3VOperating temperature range:-40to85ºCPatchAntennaSize:15x15x4mmModule Size: 16.1x16.1x6.65mmCommunication type: UART/TTLRoHS compliant (Lead-free)
1.2.Power Supply Regulated power for the DL-1616N-GCMFis required.The VCC Pin Need Plastic Machinery a stable DC voltage supply. Power supply ripple must be less than 30mV.The input voltage Vcc should be 2.8V~4.3V, Recommended power supply voltage is 3.3V. maximum current is 20mA. Suitable decoupling must be provided by external decoupling circuitry. 1.3.UART Ports The module supports two full duplex serial channels UART.All serial connections are at 3VCMOS logic levels, if need different voltage levels, use appropriate level shifters. The baud rate of both serial ports are fully programmable, the data format is however fixed: X, N, 8, 1, i.e. X baud rate, no parity, eight data bits and one stop bit, no othGrinder er data formats are supported, LSB is sent first. The modules default baud rate is set up 9600bps, however, the user can changethe default baud rate to any value from 4800 bps to115kbps. UARTport can be used for firmware upgrade, NMEAoutput and PMTK proprietary commands input.
2.Application
The module is equipped with a 5-pin pad that connects to your application platform.The DL-1616N-GCMFmodule It consists of a MediaTek MT3339single chip GNSS IC which includes the RF part and baseband part, a patch antenna, a LNA, a SAWfilter, a TCXO, a crystal oscillator.2.1. Pin Assignment

Figure 2: PinAssignment2.2.Mechanical Dimensions This chapter describes the mechanical dimensions of the DL-1616N-GCMFmodule. Size unit(mm)Figure 3: Specification size chart