China PU Lacker PU Wood Lacker Furniture Lacker

Exporter Pioneer-Maydos 2k PU Resin Wood Furniture Coatings
Preparation and AppliColor Card & Color Comparator cation:Finishing (topcoat) highlights the beauty of wood, but the process also magnifies imperfections. Sand the wood smooth and repair all defects before finishing.
1. To produce smooth surfaces on bare wood, always sand with the grain of the wood. The material should go through at least three sandings with successively finer grit sandpaper. Start with 80 grit, move to 150 grit and finish with 220 grits. Use a tack cloth to remove dust between sandings. If you are using paint as a topcoat over another finish, simply scuff sand the existing finish with steel wool or syEnvironment Protection Device nthetic steel wool. Scuff sanding gives the paint topcoat something to bite into for better adhesion with the existing finish.
2. On bare wood, apply a light coat of paint and alSpraying Machinery & Spreading Equipment low it to dry fully. After the first coat has dried, lightly sand, witPneumatic Component h fine grit paper, to remove any raised grain. On an existing finish, apply a coat of paint and allow it to dry according to the manufacturer's instructions before.
3. Sand the dried paint lightly with 400 or higher grit sandpaper, steel wool or synthetic steel wool. Remove any sanding dust withTools & Hardware Stocks a tack cloth.
4. Brush or wipe on another coat of paint and allow it to dry.
5. Continue to apply coats of paint as indicated in steps 2 through 4 until you achieve the surface build-up you desire.
6. Inspect the finish for small nicks or imperfections. Rub out any rough spots with steel wool or synthetic steel wool. Wipe with a clean tack cloth to remove any dust. For extra protection, polish the surface with paste wax or furniture polish