China Toggle Bolt Anchor Spring Toggle Bolt

Toggle Bolt Anchor/Spring Toggle Bolt (ZP , YZP, Galvanized, Plain, etc.)
Specs:

Anchor SizeWing Length(mm)Drill HolePull out Load Kgs Qty/Box

M3

34 10mm 130 200 M4 39

12mm

150 200 M5 50

14.5mm

200 200 M6 53 16.5mm 500 200 M8 66 20mm 500 100 M10 74 23mm 550 50 1/8" 34 3/8" 130 200 3/16" 50 1/2" 200 200 1/4" 53 5/8" 500 200 5/16" 66 3/4" 500 100 3/8" 74 7/8" 550 50

Drill the correct size hole to enable the wings of the toggle to pass through the material being fastened to. A sharp drill bit with minimum pressure will prevent damage at the break through point.Pass the screw through the fixture being fastened and re-assemble allowing the end of the screw to slightly pass through the yoke.Close the wings back along the length of the screw and check that there is sufficient length of screw to enable the wings to clear the thickness of material being fastened into.Install the fixture against the wall guiding the toggle through the hole and pressing home until it falls down into position or springs open into position. Check that the wings have opened/ fallen into place by pulling back on the fixture.Tighten the screw, at the same time, pulling back on the fixture to keep the toggle in contact with the reverse side of the work surface. Do not over tighten to avoid stripping of the threads in the yoke.