120W Long Distance 8 Port Gigabit Poe Network Switch 250m

120W long reach distance 8 Port Gigabit Poe Network Switch 250m
DF-1.25G-8P-E/F is a 8-Port Gigabit PoE Switch with 8 PoE Ports, 1 SFP Gigabit Uplink Optical Ports, port 1 to port 8 supports PoE IEEE 802.3at international standard, each port power is 30W. Total power is 120W.
This POE network switch can meet customer's general demands. POE network switch with POE function, designed for high-definition network camera's internet access. It provides 8 1000Mbps PoE Ethernet switches, complies with IEEE802.3af/at standards, and also simplifies wiring, avoids the troublesome of installing power socket for powered devices.Typical applications please refer to following picture.1.Features9/10-Port Gigabit PoE Switch with 8 PoE Ports, 2 SFP Gigabit Uplink Optical PortsSupply power to wireless access points AP and network IP surveillance camerasPort 1 to Port 8 supports IEEE802.3at power (each port maximum power is 30W)8x 10/100/1000Mbps ports +1/2x SFP gigabit optical uplink portsCompatible with IEEE802.310i and IEEE802.3u standardThe packet forwarding speed is 1.488Mbps of one wire-speed portPort features with auto-flip(AutoMDI/MDIX)Network port comes with lighting-proofAll ports support wire-speed switching, frame size within the range of 64 to 1536 can achieve wire-speedAutomatic adjustment, plug and play, no need software and protocol conversion2.HighlightsNoframe Loss IP Data TransmissionPoE+Standard 250m in One-key CCTV Mode10 KB Jumbo frames supportFew video time delay4KVLightning Protection
3.Technical SpecificationsItemDescriptionModelDF-1.25G-8P-1/2FPower SupplyPower Supply ModeMains on loadVoltage RangeAC 100~240VPower ConsumptionThe device <5W, POE power supply <120WNetwork Port ParameterNetwork Ports1~8 Ports: 10/100/1000Mbps Ethernet port, adaptive control
Uplink or SFP:1000MbpTransmission Distance1~8 Ethernet Port:0~100m
Mandatory 10 Mbps reach up to 250m
1 fiber: 550m-120kmTransmission Media1~8 Ethernet Port:Cat5e/6 standard UTP cable,
1 SC interface optical fiberPOE AgreementIEEE802.3 af/at standardsPoE Power Supply ModeEnd-span methodPoE Power Supply WattageEach port≤30W,Whole device<120WNetwork Switch SpecificationNetwork StandardIEEE802.3 10base-T, IEEE802.3u 100base-TX, IEEE802.3ab 1000base-TSwap ModeStore-and- forwardSwitch Capacity20GbpsMAC Address List8KStatus IndicatorsPower Indicator LightOne power light (green)Optical Fiber Port Indicator One fiber link indication light ( green), Green light keeps on when the fiber port is well connected; Blinking when transceiver dataPoE Indicator 1~8 PoE indicator light(yellow)PoE Network Port LED1~8 port ( green light on RJ45 jack) Keeps on when normally connected, Blinking when transceiver dataSwitchSwitch 1(Vlan)ON: Vlan open, 1 to 8 POE ports only can communicate with uplink port; OFF: Vlan close, normal statusSwitch 2(CCTV Mode)ON: Vlan open, 1 to 8 POE ports only can communicate with uplink port, power and data can reach 250 meters;
OFF: Vlan close, normal statusProtection LevelSurge ImmunityLevel 3, executive standard:IEC61000-4-5Electrostatic Protection1a touch electric discharge: level 3 1a Air discharge: level 3 Executive standard:IEC61000-4-2Operating EnvironmentWorking Temperature-10ºC~55ºCStorage Temperature-40ºC-85ºCHumidity(non-congeal)0~95%Mechanical AttributesDimensions (L*W*H)188.5mmx102.5mmx28.25mmColorBlackWeight1kgReliabilityMean time between failures (MTBF)>50000h
Note:
If any changes with product specification, forgive without prior notice.
1) As transmission distance has certain relation with the cable, so you are suggested to use standard cat5e/6 cable for longest distance needed.4.V-lan4.1 Introduction
When V-lan function is opened, the LAN port can't make data conversion but can only communicate via uplink port. The V-LAN workstation is built separately between every network port and UP-link port.
In the same V-lan workstation, no matter which actual PoE switch being connected, the signal transmission are separately isolated from each other which seems they are on the different switches. The broadcast in the same V-lan can only be received by the members but can't be transmitted into other V-lan, which can greatly control unnecessary broadcast storm. What's more, different V-lan can't even communicate with each other when there is no routing, which increases the safe degree among different department in the enterprise.
4.2 Configuration
Toggle the V-lan button on the back of the switch to ON state, V-lan indicator lights, then press the reset button to restart the switch, in this way V-lan functions.
Note:
Please press reset button or repower the device when turn on V-lan, only in this way the switch can enter corresponding mode.5.Package accessoriesPacking List
1) 1 set of 8 port poe switch
2) 1 AC cable
3) 1 user manual
Would you like a 8 port poe switch to test?Please leave me an inquiry or contact me directly.