14 Slots Media Converter Rack, for Fiber Media Converters, Dual DC48V PSU Included

Product Overview
The 14 slots media converter chassis supports plug-and-play installation of stand-alonemedia converters convert modules ,can hold at most 14 pieces media converters.
And structure , it can work stably and adapt broad width of voltage .It can store strong power and can be operated and managed easily. The maintenance of this chassis is also very easy. This option is the very one to meet the requirements of good stability , high capacity , good integration and good quality .
This option supports hot-swap convert modules .It can work with single power supply or dual power supply as users wish, when the power supply should be maintained or changed ,it is not necessary to pull-out the converters ,this makes the maintenance easy. With all these advantages ,this option can supply users with an effictive solution of networks.
Specifications1.Number of slots :14 Media converters adapted :
14 slots chassis : 10/100M or 1000M or 10/100/1000M stand-alone media converters Power in :AC 100 V~260 V ; OR DC 48V Power out :DC 5V , 12A Diameter of DC plug :2.5/5.5 mm Ripple≤50 Mv Noise :≤50 Mv Protection of power supply :circuit-breaker when overvoltage ;circuit-breaker when overflow ;circuit-breaker when short circuit Operating Temperature :0ºC~50ºC Storage Temperature:-20ºC~85ºC Humidity: 5%~95% Dimensions:L485 ,W231,H90 mm ;19 inches 2U
Fault And Maintenance Of Media Converters
Fault descriptionCause descriptionMaintenancePOWER LED Lamps are off Haven't connected the power plug or not a valid connection Connect the power plug and make sure it is a valid connection link/Act LED Lamp is off 1.Haven't connected the electrical cables to the electrical port or not a valid connection Connect the electrical cables to the electrical port and make sure it's a valid connection 2.Used the wrong electrical cables for electrical connection Use right type of electrical cables for electrical connection 3.Any fault with the NIC and the terminal of Ethernet To make sure the NIC and the terminal of Ethernet can work normally
FX and FX-link/Act LED Lamps are off1.There might be any fault with the terminal optical devicesCheck the terminal optical devices and the main fiber to see if they can work normally. If not ,then maintain them 2.The optical fiber has broken down or the connection of optical fiber is not valid3.The optical fiber is over-lossTX and FX LED Lamps are normal but the data can not be transmitted 1.The connection between optical fiber and devices is not valid ,this will ause the TX power not strong enough 1.Check the fiber connectors and make sure the connection between optical fiber and devices is valid 2.The system get power just for a little moment or any changes for the network ,these may cost a little time for media converters to adapt 2.If this option can still not work a long time after all installations, then stop the power supply ,wait a little moment and try again
with the power on