C40 Touch Screen 125kHz RFID Standalone Single Door Access Control

Touch Screen 125KHz RFID Standalone Single Door Access Control
Key Features:
1.Strong Zinc Alloy Electroplated anti-vandal case
2.Frequency: 125Khz or 13.56Mhz
3.Indoor or Outdoor use ,IP65
4.Full programming from the keypad
5.8000 uses, supports Card, PIN, Card + PIN
6.Can be used as a stand alone keypad
7.Backlight keys
8.Wiegand26/34 input and output port. output for connection to a controller
9.Adjustable Door Output time, Door Open time
10.Very low power consumption (30mA)
11.Fast operating speed, <20ms with 8000 users
12.Lock output current short circuit protection
13.Easy to install and program
14.Built in light dependent resistor (LDR) for anti tamper
15.Built in buzzer, Red, Yellow and Green LEDS display the working statu
Specification:OperatingVoltage 12V~24VDC UserCapacity 8000 CardReadingDistance 3-6cm ActiveCurrent <50mA IdleCurrent 25±5mA LockOutputLoad 3A OperatingTemperature -20~70 DegreeOperatingHumidity 0%-95%RH AdjustableDoorRelaytime 0-60seconds WiegandInterface Wiegand26/34bit WiringConnections ElectricLock,ExitButton, Slaver ReaderDimensions L135x W46x H22 mm
Quick Reference Programming GuideTo enter the programming mode* Master code #
123456 is the default factory master code
7890 is the default factory initial opening passwordTo exit from the programming mode* To change the master code0 New code # New code #
The master code can be 1 to 8 digits To add a card user1 Swipe Card #
Cards can be added continuously without
exiting programming modeTo add a PIN user.2 User ID number # PIN #
The ID number is any number between 1 & 2000. The PIN is any four digits between 0000 & 9999 with the exception of 1234 which is reserved. Users can be added continuously without exiting programming modeTo delete a PIN or a card user. 4 User ID number # for a PIN user or
4 Swipe Card # for a card user
Users can be deleted continuously without exiting programming mode