China 10 100 1000m 1 Sc Optical Port + 8 RJ45 Port Fiber Poe Switch

10/100/1000m 1 SC Optical Port + 8 RJ45 Port Fiber POE Switch
DF-1.25G-8P-1E is a 10-Port Gigabit PoE Switch with 8 PoE Ports, 1 SFP Gigabit Uplink Optical Ports and 1 Gigabit RJ45 Uplink port, port 1 to port 8 supports PoE IEEE 802.3at international standard, each port power is 30W . Total power is 120W.
This POE network switch can meet customer's general demands. POE network switch with POE function, designed for high-definition network camera's internet access. It provides 8 1000Mbps PoE Ethernet switches, complies with IEEE802.3af/at standards, and also simplifies wiring, avoids the troublesome of installing power socket for powered devices.

1.Features10-Port Gigabit PoE Switch with 8 PoE Ports, 1 RJ45 uplink, 1 SFP Gigabit Uplink Optical PortsSupply power to wireless access points AP and network IP surveillance cameras Port 1 to Port 8 supports IEEE802.3at power (each port maximum power is 30W)8x 10/100/1000 Mbps ports + 1RJ45 + 1x SFP gigabit optical uplink ports Compatible with IEEE 802.3 10i and IEEE 802.3u standardThe packet forwarding speed is 1.488Mbps of one wire-speed portPort features with auto-flip(Auto MDI/MDIX)Network port comes with lighting-proof All ports support wire-speed switching, frame size within the range of 64 to 1536 can achieve wire-speed Automatic adjustment, plug and play, no need software and protocol conversion2.HighlightsNo frame Loss IP Data TransmissionPoE+ Standard 250m in One-key CCTV Mode10 KB Jumbo frames supportFew video time delay4KV Lightning Protection3.Technical Specifications

ItemDescriptionModelDF-1.25G-8P-1EPower SupplyPower Supply Mode Mains on loadVoltage RangeAC 100~240VPower ConsumptionThe device <5W, POE power supply <120WNetwork Port ParameterNetwork Ports 1~8 Ports: 10/100/1000Mbps Ethernet port, adaptive control
UPlink Ethernet port: 10/100/1000Mbps Ethernet port
Uplink SFP:1000MbpTransmission Distance1~8 Ethernet Port:0~100m
Mandatory 10 Mbps reach up to 250m
1 Ethernet Uplink Port:0~100m
1 SFP: According to different SFPTransmission Media1~8 Ethernet Port:Cat5e/6 standard UTP cable,
1 Ethernet Uplink Port:Cat5e/6 standard UTP cable
1 SFP: LC interface optical fiberPOE AgreementIEEE802.3 af/at standardsPoE Power Supply ModeEnd-span methodPoE Power Supply WattageEach port≤30W,Whole device<120WNetwork Switch SpecificationNetwork StandardIEEE802.3 10base-T, IEEE802.3u 100base-TX, IEEE802.3ab 1000base-TSwap ModeStore-and- forwardSwitch Capacity20GbpsMAC Address List8KStatus IndicatorsPower Indicator LightOne power light (green)Optical Fiber Port Indicator One fiber link indication light ( green), Green light keeps on when the fiber port is well connected; Blinking when transceiver dataFE Uplink PortLED (Green): On, port is link on; Off, port is link down;PoE Indicator 1~8 PoE indicator light(yellow)PoE Network Port LED1~8 port ( green light on RJ45 jack) Keeps on when normally connected, Blinking when transceiver dataSwitch Switch 1(Vlan)ON: Vlan open, 1 to 8 POE ports only can communicate with uplink port; OFF: Vlan close, normal status Switch 2(CCTV Mode)ON: Vlan open, 1 to 8 POE ports only can communicate with uplink port, power and data can reach 250 meters;
OFF: Vlan close, normal statusProtection LevelSurge ImmunityLevel 3, executive standard:IEC61000-4-5Electrostatic Protection1a touch electric discharge: level 31a Air discharge: level 3 Executive standard:IEC61000-4-2Operating EnvironmentWorking Temperature-10ºC~55ºCStorage Temperature-40ºC-85ºCHumidity(non-congeal)0~95%Mechanical AttributesDimensions (L*W*H)188.5mmx102.5mmx28.25mmColorBlackWeight1kgReliabilityMean time between failures (MTBF)>50000h

Note:
If any changes with product specification, forgive without prior notice.
1) As transmission distance has certain relation with the cable, so you are suggested to use standard cat5e/6 cable for longest distance needed.4.V-lan

4.1 Introduction
When V-lan function is opened, the LAN port can't make data conversion but can only communicate via uplink port. The V-LAN workstation is built separately between every network port and UP-link port.
In the same V-lan workstation, no matter which actual PoE switch being connected, the signal transmission are separately isolated from each other which seems they are on the different switches. The broadcast in the same V-lan can only be received by the members but can't be transmitted into other V-lan, which can greatly control unnecessary broadcast storm. What's more, different V-lan can't even communicate with each other when there is no routing, which increases the safe degree among different department in the enterprise.
4.2 Configuration
Toggle the V-lan button on the back of the switch to ON state, V-lan indicator lights, then press the reset button to restart the switch, in this way V-lan functions.
Note:
Please press reset button or repower the device when turn on V-lan, only in this way the switch can enter corresponding mode.
5.Product view

6.Certificate
7.Exhibition
8.Company
Our Services:

1.Order inquiry: Keep working time from 9AM to 23PM to gurantee the first reply to clients,and 24 hours no Cellphone power off

2.Order production: Keep very close touch with production department to gurantee the right delivery time to clients

3.Before shipment: Our sales would double check the order quantity,package and strength of cartons to avoid lost and damage

4.After shipment: Keep tracking shipping status and reporting to clients

5.Shipment: DHL,UPS,FEDEX,TNT,EMS,SEA,AIR etc.

If you interest or have any question, Why not send inquiry? Welcome & Just Do It !!!