China 1W 2W 3W High Power LED Sign Board Light Box

I,Features:Take TOP3030 LED as light source, no light spot, low decay and good consistency.Low consumption, high brightness, free maintenance, long life span.Injection outer cover, beautiful and unique appearance, good heat dissipation.Input voltage: DC12V, reliable and safe.With series-parallel connection circuit for LED PCB, 20pcs modules are connected to one string and each module can be cut individually.II,Applications:Widely used in 8-20cm depth of light-emitting character, advertising signage, advertising lighting box, local lighting.III,Parameters: Optical Parameters:NameLEDcolorCT (K)voltagePOWERLumen (LM)Effect
(LM/W)angleMD1L3030SMD3030White6300~700012V1.5/2/3W 300110
160°
7000~8000Other parameters:Connection QtyShell colorDrive methodWeight (g/20pcs)WarrantyW T(ºC)S T(ºC) IP Level 50pcsWhite Constant voltage 3003 Years
Or 15000H-25-+60 -25-+80 IP65:The test ambient temperature is 25±2ºC;
The above data is typical, the actual parameters of the product may be different from the typical data.IV,Spot map and light distribution curve:

V,Dimensional Drawing(Unit: mm):
VI,Installation Instruction:

Method 1:
1,Connect the first LED module into the main power. Max number is 20 PCS.
2,Isolate cable ends to prevent short circuit.

VII,Notes:
Usually, main power cable dimension is 2x1.5mm². To prevent damage from overheating caused by overload, it is essential to take 0.75mm²/18# wire as main power cable if necessary. Cable length between power and module should not exceed 2m. If over 2m, it will increase total power consumption.Take method 1 for installation (single end power supply), maximum is 20 PCS. (No over-connecting)Take method 2 for installation (both ends power supply), maximum is 50 PCS. (No over-connecting).1,Take off release paper from adhesive tape at the back of modules. 2,Stick modules inside light box or advertising signage for initial setting. 3,Fix module by 1piece of ST2.9x10 mm self tapping screw or by glass glue at both sides of module.Standard connection number is 20pcs for each string; Cut into each piece as to actual requirement.During the connection, use diagonal pliers to cut off power cable between modules, peel off the plastic around 10mm, wire the cables and then connect
them to their respective isolation port (the white-red cable heads to positive, the white cable for negative). Do remember check the conductivity and reliability of the cable after the connection, generally, they can't be pulled out of the port by middling force.Peel off the cable coat by 10mm (around) then connect then into isolation port if there are extra cables for the string-end module.Make sure that the waterproof and anti-corrosive reliability; grease some silicon glue (neutral glass glue or waterproof glue) into the connection port for further protection. Don't touch the product when they are electrified.
Related Photos