China 400m Bush Hammer Disk for Removing Thin Coatings

bush hammer tools create a bush-hammered profile on concrete, ideal for use on exterior spaces and creating anti-slip surfaces. The BSD Bush Hammer rollers are designed to pulverize the surface of concrete making it fast and easy to get full aggregate exposure. It is also a great option for removing thin coatings when prepping the floor for epoxy application. However, these tools are NOT intended to remove any flexible coatings or most epoxies. Each bush hammer assembly comes with 2 components - the hammer plate, and a set of 3 rollers with fastening screws (12 Screws and 12 lockwashers - 4 per roller). This 2 component system is packaged and sold separately so that you can purchase the Bush Hammer Roller Assembly separate for multiple uses with the same Hammer Plate. The Bush Hammer Rollers can be used on Sase, Husqvarna, and Diamatic machines with the use of the Hammer plate system. Bush hammers are not recommended for use with high rpm machines and should be run at no more than 700 rpms. • Aggressive profiling tool that breaks down the surface that standard diamonds can't touch. • Removes old glue and resin coatings, particularly thick resins. • Provides a good bonding surface or anti-slip finish on concrete, granite, and marble • Long lasting tool - up to 15,000 SF when used properly (Avoid steel and other obstructions in floor to maximize life). • Two Separate Components to maximize value and get the most life from the reusable Hammer Plate. • Bush Hammers come fully greased, and grease should be added before each use being careful not to over grease and blow out the seals.