China AS-AMCP Addressable Manual Call Point

Product overview

The AS-AMCP manual fire call points is mainly designed to be used with an intelligent two-bus control system. If it is pressed after a fire is manually /confirm/ied, an alarm signal may be sent to a fire alarm control system which will, after receiving the alarm signal, display the coded address and the equipment status of the manual fire call points. When the manual fire call points is operating normally, the red indicator will blink; when there is a fire alarm, it will remain lit. The manual fire call points supports electronic coding and has a built-in fire telephone jack and a PHONE indicator, making its engineering application convenient.
Product features
It can realize complete electronic coding and in situ rewriting with help of a coder.
Designed with an upper cover and a lower cover, it can be installed, debugged and maintained conveniently.
It is designed with a two-wire fire telephone jack and is therefore more applicable to engineering application.
Designed with passive output contacts, it can control other external equipment directly through an intermediate relay.
The pressing sheet on the manual fire call points will not get crushed after it is pressed, but can be reset by a special tool, so it can be used repeatedly.
Technical parameters
1. Executive standard: EN54-11
2. Operating voltage: 24V (pulse modulation)
3. Operating current: <300uA (in the monitoring status); <2mA (in the action status)
4. Output contact: Normally open contact; capacity: 0.1A/30VDC
5. Weight: about 120g
6. Wiring method: nonpolar two-bus system (L1, L2)
7. Operating environment: Indoor, temperature: -10ºC~+50ºC; relative humidity: ≤95% (40ºC±2ºC, without condensation)
8. Coding method: It can realize online coding with the help of a coder and without the necessity of disassembling the bus (however, the equipment must be powered off). Address codes 1 to 324 are available for selection.
9. Telephone jack: Two-wire fire telephone jack (equipped with a standard Ф6.3 single-track audio connector).
10. Starting part: A plastic pressing sheet that may be used repeatedly. It can be manually reset with a special tool after being pressed.
11. Starting mode: Press the pressing sheet manually.
12. Indicator: The red ALARM indicator will blink in the inspection status or remain lit in the alarm status; the PHONE indicator will blink when a fire telephone loop is connected, otherwise it will be out.
13. Matched host machine: AS-MN3010
Wiring method
Completed Fire Alarm System

Company:

ANSORL LTD is a building automatic control system and fire alarm system solution provider. Over the past years, We have always been dedicated to serving the diverse needs of our customers. Although we started out as a tiny engineering and manufacturing company in China and have grown into a global player in the international safety market, Ansorl continues to work hard to earn your trust and retain your confidence in our product line.

We focuse on providing advanced buidling automatic control system and fire alarm / fire fighting system. Ansorl works harder to tailor our solutions to meet your needs.

Ansorl is an ISO 9001:2000 certified manufacturer with number of testing facilities. We are also planning to expand our manufacturing and testing facilities in China to ensure that our products and manufacturing practices continue to meet the highest standards.

We invite you to get to know Ansorl better. Experience the best fire alam technology and solution. We are convinced that you will find Ansorl superior to any other detector company in China. You'll see it in our facilities, in our people, and in the products that Ansorl makes. It's our uncommon commitment to excellence and quality, and to the automation and productivity of our customers.