Slurry Pumps, G12110 A05, Volute Liner manufacturer / supplier in China, offering 14/12 St-Ah Slurry Pump Volute Liner (G12110 A05), Electric Slurry Mud Sludge Trash Pump (2PN /3 PN /4 PN), Carbon Steel / Stainless Steel Discharge Flange Pipe for Pump and so on.
Min. Order / Reference FOB Price | |
---|---|
1 Piece | US $1411.00/ Piece |
Local Area: | Huaan, Jiangsu, China |
---|---|
R&D Capacity: | OEM, ODM, Other |
Payment Terms: | LC, T/T, PayPal |
Max.Head: | 50-80m |
---|---|
Max.Capacity: | >400 L/min |
Driving Type: | Motor |
AH Mining Slurry Pumps
Naipu NP-AH(R) series centrifugal slurry pumps and spare parts can fully interchangeable with world famous brand. These pumps are of heavy duty construction, designed for continous pumping of highly abrasive and corrosive slurries. They feature a wide choice of replaceable abrasion resistant metal or molded elastomer casting liners and impellers, which are all interchangeable within a common casting assembly.
Typical Application-
Mineral Flotation Processing
Electric Factory Coal preparation
Coal Washing
Chemical medium processing
Sand and gravel handling
Effluent Handling
Construction Drawing
Pump Performance Parameters
Product Overview:
Our Workshop Show:
Possible Faults and Settlements
Faults Reason Settlement1.Pump fails to discharge any water,The hand of pressure gauge beat violently 1.Suction pipe don't have enough water.
2.Suction pipe blocked or the valve is locked.1. Inject enough water
2.unlock the inlet valve,clear the blocks
3.Exclude the air leakage 2.The pump can't discharge water,the hand of vacuum meter beat heavily. 1.The inlet valve is unlocked or silted up.
2.The resistance of suction pipe is too big or silted up.
3.The height of suction is too high. 1.Unlock the valve or desilting
2.improve the design of suction pipe or desilt
3.Lower the height of the installation.3.The pump can't discharge water,pressure gauge shows heavy pressure.1.The resistance of the discharge pipe is too big.
2.The impeller blocked
3.The speed is slow.1.Check and adjust the outlet pipe.
2.Clear the impeller
3. Improve the speed.4.The pump doesn't rotate The volute is silted up by the blocks. Clear the blocks5.The capacity is not enough 1.The blocks of the impeller or the inlet or outlet pipe.
2.The abrasion of the impeller is heavily.
3.The speed is low to normal
4.Pump is installed unreasonably or the leakage of the inlet pipe.
5.The transporting height is too high,the loss of the resistance of the inside pipe are too big.
6.The inlet valve not open enough or blocked
7.The packing seal leaks
1.Clear the impeller or pipe.
2.Change the impeller
3.Adjust the speed
4.Install again or stop leaking.
1.The resistance of the inlet pipe is too big.
2.The height of the suction is too high.
3.Cavitation occurred
Contact Us