China Automatic Powder Coating Paint Spray Robot Reciprocator

Automatic Powder Coating Paint Spray Robot Reciprocator
Automatic reciprocators is a important parts of a automatic powder coating line,it is work with severals electrostatic powder coating guns. Max.Can hold up to 8 automatic guns at one time,standard hold 4 guns.And features up 80 storable settings.Frequency-adjustable reciprocator is specially designed for high quality powder coating and also optional for wet painting guns as well.The System Is Available In 3 Different Stroke size for 1.5m,2.0m,2.5m.
The Benefits of CL-2000D:
1.Janpan Mitsubishi Inverter,speed adjustable by inverter
2.Digital intelligetn moel,80 storable programs
3. Wheel back and forth movements
4. Stroke:1.5m//2m/2.5m/
5. Four automatic spray gun rods(qty of rods can be ordered)
6. Extremely smooth running through chain
7. High loading capacity and stability
8. Long stroke and short stroke operation
Technical Parameters

Power supplyAC 220V/110V 50HZ-60HZPower motor0.75KWSweep speed0~50M/minAcceleration1m/secondEnvironmental0~50degreeStar signal modeldigital displayMax.load capacity25kgsMotion range0.3~2.5m(can be setting)Point delay time0~50sec(optional)

Main parts of the electrostatic powder painting reciprocator
Controller Description

DisplayDescriptionA1Light NO1A2Light NO2A3Upward moving----see PIC 01A4Downward moving---See PIC 02A5Auto modelB1Actual valueB2Program modeB3Manual/auto swich keyC1Top stroke settingC2Bottom stroke settingC3Speed settingD1Manual model switchD2Power switch OFF

Operation
First, on the "program" display ,make it "1",then push the key ↑,and make the spray gun move to the workpiece top place ,at this time please check the data on the "m" display ,make the m data minus 80(m-80=A),make A as the upper limit value. Push the key ↓,and make the spray gun move to the workpiece bottom place ,at this time please check the data on the "m" display ,make the data plus 80(m+80=B),make B as the lower limit set value .Make the speed data(Hz) as about 10,push the key "ON" to start the reciprocator ,push the key "OFF" to stop it .You can change the "HZ" data to find the best moving speed .In this case ,if the upper limit is not high or not low enough ,you can increase or reduce the data .Now the setting for the mode 1 is finished ,all the data will be in the mode 1 memory
Supporting equipment
Match with automatic powder coating gun and control cabinet.