China Automatic Powder Management Machine Powder Feed Center

Automatic vibrating powder feed center for fast color change- a good helper for powder operator

1. Powder's smoother fluidization

2. Maintain good working environment
3. Make the gun powder supply more uniform
4. Discharge operators from the problems of powder gun powder supplying.
5. Greatly reduce the labor intensity and powder influence on operators' healthy during cleanup process.
6. Easier to change color

Automatic vibrating powder feed center parameters

1. Power supply voltage: 1P 220VAC (110V)
2. Power: 500W
3. Gas pressure: 0.6-0.8MP
4. Equipped with up to 16 powder pumps at most.
How to operate the powder feed center
1.Starting up

3. Start or stop pump platform level
Press more than 3 seconds to make sure no wrong operation.
4. Powder gun cleaning
Close fluidization key- Close pump platform level key-Unplug the fluidization air quick connector-Remove the powder hopper-Press the pump platform level key for more than 3 seconds- Pump platform level falls and make the suction tube plug into the blowback nozzles-Press the blowback key.
Then the powder supply center will automatically backflow and clean the powder tube, venturi pumps, pipes and powder guns as per the setting pulse time. After cleaning, press backflow key to close, and then press pump platform level for more than 3 seconds. And pump platform rises to high level. Powder cleaning ends.

How does powder feed center work?
Put the powder hopper full with powder in the powder supply room, and on the powder hopper vibration platform, and then access the air for the fluidization of powder. Vibration platform will vibrate at intervals. Powder particles generated in the process of fluidization goes through the rear ventilation pipe so that powder doesn't spill. In the process of powder gun working, the powder pump station will be decreased, so that the suction tube is inserted into fluidizing powder.
Control the pump station decreasing by powder detecting sensor, so that the powder suction tube keep been inserted into the sufficient fluidization powders. With powder level declining, when the powder level reaches the lower limit, the powder center of the electronic control system will issue audible alarm and on the touch screen with character note. Remind the operator low powder level alarm, and he or she needs to add powder. In the cleaning process, lower the pump platform down to the powder cleaning level. Open and clear the powder. Powder center automatically blowbacks the powder gun hoses of both sides alternately.
If change the color, rise the pump station to higher point for the powder hopper can be easily removed, and then carried the powder hopper with required color in.