China Brass Angle Ball Valve with Handle

High Quanlity Aluminum Handle Ball Valve Male End Female

Material: Forged Brass ( CW617N, CW614 ,CW602N,ASTM C37700)

Size: DN15x1/2"x1/2",

Thread standard: Free Nut according to ISO228, ISO7/1, DIN2999/DECA fittings
For the handle, it could be changed to magnetic Type, Brass Handle, or Zinc Alloy Handle

Package details: Each valve by one polybag, inner box, Cartons with pallets

Technical Specification:

Working pressure: 1.6Mpa

Tested Pressure: 2.0Mpa

Working medium: Water, oil, gas

Working temperature: -20° C≤ T≤ 120° C

1Before Installing the valves, clean and remove any objests from the pipes2Ensure both connection pipes either side of valves and aligned3Ensure that two sections of the pipe match, and the valves until will not accept any gaps, any distroy in the pipes may affect the tighting of the connection, The work of the vales and can even casue a rupture. To be sure, place the kit in position to ensure the assembling will work4Before starting the fittings, ensure the threads and tappings are clean5If secton of pipes have not their final support in that place, They can be temporatily fixed, In order to avoid unnecessary strain on the valves6The theoretical lenghts gived by ISO7/1 for the tapping are typically longer than required, The length of the thread should be limited, and check that the end of tube does not press right up to the head of the thread7For the sealing assembly valves pipes, it is essential to use products that are compatible with the requirements of the clean water meter8Position the pipe clips on both side of the valves9If mounting on an air conditioning with Per tubing and hoses, it is is necessary to support the tubes and hoses with the fixed to abvoid strain on valves10When screwing the valves, ensure you only rotate on screws side by the 6 ended side, Use an open ended spanner or an adjustable spanner and not a monkey wrench. Never use a vice to tighten the fixing of the valves11Do not over tighten the valves, Do not block with any extensions as it may cause a rupture or weekening of the forging strenght. The Torque force not more than 30Nm

General Guidelings :

1Ensure that the valves to be used are appropriate for the condition of the installation2Be sure to have enough valve to be able to isolate the section of pipes as well as the approciate equipment for maintenance and repair3Ensure that valves to be installed are of correct strenght to be able to support the capacity of their usage4Installation of all circuits should ensure their function can be automatically tested on a regular basis ( at least two times per year)

Why Choose US

We control the material of PTFE(Teflon) and stainless steel wires per customer's request.

Some are from Japan and Taiwan, some are from China local. only choose high quality material.
We test leakage of each roll before braiding, then we cut 300mm and crimp it to test

burst pressure after brading.
We use CNC Lathes Machine for end fittings production. Machine system, knife and inspection

tools are all imported from Japan.
We use Techmaflex Crimping Machine which is imported from France. This machine has

accurate and stable performance for crimping because it is produced for PTFE hose crimping only.

Contact to this supplier