China Bridge Pot Bearings Supplier

Contact informations :Jenny Lee,
Phone:86 18678456530
Office number:86-0318-8538202
Fax:86-0318-2210707
Website:www.zqdcrubber.com,
www.bridgebearing.org
Our factory production process ofPot bearing:
Machining workshop and machine works:2.Finished machining half-finished products and Spraying process
3. Applying silicone grease :
4.and embedded bolts
5. Assembing of pot bearings and store
Bridge bearings and expansion joint are important parts of whole bridge components,but the amount money that spent on bridge bearing and expansion joint is only 2-3.5%, it is absolutely awise choice to evaluate it within the whole project to prevent failed choice bringing unnecessary costs.1.Description
Pot rubber bearing is used to semi closed steel in pelvic cavity of the elastic rubber block, in three to the stress state has the characteristics of fluid to achieve the rotation of the upper part of the bridge, also rely on steel plate in the center of the F4 board and the upper seat plate of stainless steel plate between the low friction coefficient to realize the horizontal displacement of the upper structure, bearing to withstand the shear no longer by the rubber completely bear, and indirect effects on the steel bottom slip between the pot and F4board and so on.This series bearing capacity is 31 levels, bearing capacity 0.8MN-60MN, can meet the needs of large-scale construction of the bridge.2.Advantages of pot rubber bearing
Large horizontal displacement, flexible rotation, light weight, compact structure, simple structure, low construction height, convenient processing and manufacture, saving steel, reducing the cost and other advantages, is suitable for the use of alarge bridge bridge is an ideal bearing.3.Performance and classification
a.Two-way active support: with avertical rotation and vertical and horizontal slipperformance, code named SX.
b. One way movable support: with avertical rotation and asingle direction of slipperformance, code named DX.
c. Fixed bearing: only with vertical rotation performance, code named GD.4.The technical datas of elastomeric pads inside pot bearingsITEMSCommon TypeWinter HardnessCRNREPDMTensile Strength (Mpa)≥191916Elongation At Break (%)≥450500350Adhesive Seperating Strength
with PTFE at 180°C kgf/2.5cm554Brittleness Temperature≤-40-55-65Compression Set (%) (70°Cx22H)≤303030Ozone Resistance 1PPm30°Cx100hNo CrackingNo CrackingNo CrackingAging Factor%≥0.80.850.8Hardness (Shore A)60±560±560±5
5.Technology performance
a. The vertical rotation angle of the bearing is not less than 40
b. The vertical bearing capacity (KN) of 1000 to 50000 is divided into 28 levels, the
bearing capacity of non slip surface is uneven vertical 10.
c. Friction coefficient: normal temperature typeμ≤0.04,hardy typeμ≤0.06.