China CD6280 with Gap Common Horizontal Lathe

CD6280 SERIES HORIZonTAL LATHE
CD6280 series is horizontal lathe used for machining various kinds of steel parts. It is especially suitable for mass production of machining inside and outside cylinder surface, end surface, metric and inch thread etc. It can also perform the function of drilling and boring hole.
Main features:
1. Dynamic sliding bearing is adopted on spindle nose. The bearings have better
precision and obtained state patent.
2. The spindle has 18 manual speed grade. The speed
rang of spindle is 12-1000 r/min. Large spindle bore (120 mm).
3. The lathes are supplied
with two systems both in metric and in inch.
4. Electric system of different frequency and
voltage can be designed to meet the requirements of users.

SPECIFICATION
MODELS
CD6280
CAPACITY
Max. swing diameter over bed 800
Max. swing diameter over cross slide 550
Max.swing on gap1000
Width of bed 410mm
Max. length of workpiece 1000 1500 2000 3000 4000 5000 6000 8000

SPINDLE
Spindle noseD11
Spindle bore diameter120mm
Taper of spindle bore 1:20
Range of spindle speed 12-1000r/min 18 18Kinds

FEEDS
Longitudinal feeds range0.082-1.59mm/r 35 35Kinds
Transversal feeds range0.027-0.522mm/r 35 35Kinds
Metric threads range 1-192mm 57 57Kinds
Inch threads range 2-24/ 30 31Kinds
Module threads range 025-48mm 40 40Kinds
Pitch threads range1-96/ 36 36Kinds

TAILSTOCK
Taper of tailstock sleeve 5Morse No.5
Travel of tailstock sleeve 250mm
Diameter of tailstock sleeve100mm

MOTORS
Main motor power 7.5kW
Rapid motor power0.25kW
Coolant pump power 0.125kW
Standard Accessories
1. Three jaw chuck 1 set 6. Foundation screws 1 set
2. Center sleeve7. Wedge nuts 1 set
3. M.T No.5 center 2 sets8.Operational manual 1set
4. Oil gun 1 set
5. Tools 1 set
Special Accessories (1500mm and above 1500mm length is standard configuration, 1000mm and below 1000mm length is special order)
1. Steady support
2. Follow rest
3. Four jaw chuck
4. Face plate
5. Drive plate