China Customizable Clutch Disc Clutch Disc

Clutch is a mechanism to transfer power by means of axial compression and release of two smooth friction plates of clutch. The greater the axial pressure of its two clutch plates, the greater the friction generated and the smoother and more normal the operation of the extruder. Under normal operating conditions, the machine generally presents stable and noiseless operation; Under the rated load, the clutch disc will not slip, seize, or disengage itself. At the same time, after the clutch plate is separated, it should also be separated completely to stop the operation of the brick machine, and there will be no other noise or incomplete separation of the two clutch plates and other phenomena. Therefore, it is necessary to adjust the clutch disc clearance in the clutch, the large clearance will lead to the slip of the clutch disc, damage the clutch disc, the small clearance will make the clutch disc is not easy to separate and so on. The reasons for skidding and incomplete separation of the clutch plate include improper clearance and the following points:
A. clutch plate and the driven pulley and the pressure between the internal and external pressure plate is not enough, make not tightly on the clutch plate and cause slip, if the clearance adjusting bad check the surface of the plate and push plate whether level off, whether have damage, generally they contact should reach more than 80%, to make two pieces of clutch disc normal contact, there will be no skid phenomenon during operation, otherwise the clamp or push into the tray must be considered such as spare parts, to avoid deformation of clutch plate burning, and other parts damaged.
B. Improper assembly may easily cause the contact surface between the clutch plate and other parts to be less than 80%. At this time will also make clutch disc grinding deviation or broken. Therefore, it is required to carefully check the flatness of each part during assembly, and observe whether the parts are concentric during the test run, so as not to cause wear of the middle pressure plate and inner gear ring.
C. If the clutch disc is found to be seriously worn, cracked, burnt or broken during operation, it must not be operated with illness. It should be shut down in time to check each part and see whether it needs to be replaced or repaired.