China Electronic Swing Bolt Fingerprint Safe Lock with Biometric Keypad

Electronic gun safe lock with time delay function
Up to 5 different user codes can be set
The user code can be set from 3 digits to 8 digits number
Any user code can be deleted seperately
Time delay function can be set from 01 minutes to 59 minutes
The master code (3-8digits) can be changed
Single user opening mode or dual control mode
Low battery warning
Wrong code input lockout function
System Initialization
Press the red reset button longer , the green light will flash, after 10 seconds you will hear long beep , it means
the system is initialized successfully, all information will be blank , the code will be recovered to factory default
code 1234
tThis fingerprint lock can be working by motorised locking mechanism
How to open with code
Input your code and press"START"button to confirm , if you hear long beep , it means the safe is opened
successfully
Swingbolt safe lock with master key as emergency override key
Register fingerprints
Press red reset button, you will hear 2 times short beep, now the fingerprint sensor will be red flash, then put your
finger on the sensor head until red light turns off. Now take your finger off and you will hear long beep , it means
your fingerprint registered successfully.
If you hear beep 3 times , the red light and green light flashed at the same time , it means your fingerprints is
registered failure.
Remark: After press red reset button, if you hear beep 3 times short , it means the fingerprints is registered fully
How to open with fingerprint
Press"START"button and the fingerprint sensor red light will flash, now put your fingerprint on sensor head until
the red light turns off , please take your finger off and you will hear 1 beep and the green light will turn on , it
means your finger opened the safe successfully.
If red and green light flashed 3 times , it means failure.
How to delete the fingerprints
Press red reset button longer, the red and green light will flash constantly, after 10 seconds you will hear long
beep, it means all user fingerprints is deleted
How to change the code
Press"1" button for 3seconds until green light on, now take your fingerprint off and input your code(factory default
code is 1234), now press"START" button to confirm with 1 beep, then input your 1-8 new code and press"START"
button to confirm and input your new code and press"START"button again, now you will hear long beep, it means
your code is changed successfully.
If beep 3 short times , it means your code change is failure