China Fangling F2500A for CNC Plasma Cutting Control System

Product Description

FangLing F2500A/FLMC2500A CNC Plasma Cutting Control system

Model:F2500A

System Characteristics:

The system upgrade adopts the u-disk upgrade mode, which is convenient, simple and practical, and provides lifelong upgrade service.
Parameter backup and parameter restore.
Support oxygen gas, plasma, spray powder and demonstration 4 modes.
Oxygen gas and plasma IO are controlled separately.
Oxygen gas automatic high, two - stage preheating, three - stage perforation.
Plasma arc pressure feedback, positioning feedback, turning Angle automatically turn off arc pressure.
Support edge cutting, for thicker steel plate can reduce preheating time.
According to the thickness of the steel plate, the speed limit can be automatically controlled at the corner, effectively preventing the burning.

Manually select the starting line or select the punch point.
Dynamic/static machining graphics display, graphics magnification/reduction, dynamic tracking cutting points in the zoom state.
Have power off, breakpoint protection memory function.
The "offset cutting" function can avoid the waste of the plate caused by the calculation error.
Can set different administrative rights and corresponding passwords, maintenance equipment manufacturers' rights and interests.
Remote control for P2P or BCD (8421) and serial RS232 mode.
Support laser to point function.
Support plasma dynamic perforation function.
Information statistics such as processing piece, running time, perforation frequency, etc.

Technical parameters:

Control shaft number: 2-axis linkage (customizable triaxial or four-axis)
Control accuracy: + 0.001mm.
Coordinate range: plus or minus 99999.99mm.
Maximum pulse frequency: 200KHz; Maximum speed: 15m/min.
Maximum number of programs: 80,000 rows.
Maximum single procedure: 4M.
Time resolution: 10ms.
System working power: DC +24V DC power input, power greater than 80W.
System working conditions: temperature 10 ºC to + 60 ºC; The relative humidity is 0-95% free of condensation.
The maximum power of the drive arc high motor: 45W(note: with T system). If more power is needed, the maximum can be selected to 200W.