China Horizontal Multistage Centrifugal Pump

application
DFH and DFF(T) pumps are mainly used
Ending air conditioning system
Centrifugal cooling system
Industrial cleaning
Tap water treatment (water purification)
Ending aquaculture
Cycling fertilization/metering system
Terminal environmental application
Ending (other) many specific USES
Operating conditions
Type low liquid temperature: room temperature 15 ºC to + 70 ºC hot water operated - 15 ºC to + 110 ºC C
Low temperature: largest + 40 ºC
Ending maximum operating pressure :10 bar
The maximum inlet pressure is limited by the maximum operating pressure to deliver the liquid
Non-inflammable and explosive liquid with thin, clean and free of solid particles or fiber.
Pumps can transport such as mineral water, softening water, pure water, clean oil and other light chemical media.
When the density or viscosity of the conveying liquid is greater than that of water, a high-power motor must be used if necessary.
The applicability of the benzene pump to a particular liquid is determined by a variety of factors, the most important of which is chlorine content, pH value, temperature, solvent and oil content.
pump
The horizontal multistage non-self-priming centrifugal pump is equipped with an extended shaft motor.
The compact structure makes the pump small in size, axial inlet and radial outlet.
The motor
The accumulator motor is fully enclosed and air-cooled bipolar motor.
Ending protection level :IP55
Ending insulation level :F
The maximum power of the single-phase motor is 22kW.
Curve condition
The following conditions apply to the performance curve shown below.
All curves are based on the measurement value of the motor at a constant speed of 2900rpm
Ending ISO9906, appendix A.
Low test using 20 ºC air does not contain water, kinematic viscosity was for 1 / s.