China Horizontal Vertical Electrical End Suction Centrifugal Pump

single stage Suction centrifugal Pump
Characteristics
1. The structure is horizontal with the same dimensions of inlet and outlet calibers in the same centerline; It can be installed in the pipeline as valve with compact, shapely, small area and low construction cost. It also can be used out of the door if it is installed with protective cover.
2. Impeller is installed on electrical machine's extended shaft with short axial dimensions and impact structure. Pumps are matched in reason with electrical machine's impellers. Radial and impeller load are well balanced during the process of transporting which makes sure it can go steadily with small vibration and voice-saving.
3. Axial seal adopts machinery sealing or the combination of machinery seal and titanium alloys sealing ring, medium-sized heat-resistant machinery seal and adopting horniness material, wearable seal in order to protract the using time of machinery seal.
4. In the part of installing and repairing, no need to tear down pipeline system. The rotor parts can be easily drew out if only taking down the pump nut.
5. Operating style can be decided by requirement on runoff and height.
6. According to the position of pipeline to decide to choose the installing method: Upright and square.
Usage
ISWB chemical centrifugal pump stainless of steel and explosion-protection applies to transport flammable chemical liquid.
Working Condition
1. Suction Pressure≤ 1.0 MPa, or the Max Working Pressure≤ 1.6 MPa, namely Suction Pressure uniting Height ≤ 1.6 MPa, Testing Static Pressure of pump is 2.5 MPa; Please give clear indication of system's working pressure. Please note it if the system's max working pressure is larger than 1.6 MPa
2. Working Temperature<40º C, relative humidity<95%.
3. The whole solid's volume of Medium should smaller than 0.1% of unit volume, granularity <0.2mm.
Note:
If the using media contain tiny solid, please indicate when ordering, or the suppliers can adopt wearable machinery seal.

Design & Material Bare Shaft , Direct Coupled with Electric Motor or EngineDesignPerformance and dimensions referring to the European standard BS EN733/DIN24255StructureHorizontal, Axial End-Suction, Single-Stage, Single-Suction, Volute Casing, Back pull-outDN32 - 250FlangeDIN2501 standard, ANSI B16.5 Class 150lb optionalCasingCast Iron standard, Ductile Iron, Stainless Steel optionalImpellerBronze standard, Cast Iron, Stainless Steel optionalShaftASTM420standard, ASTM304, ASTM316, ASTM1045 optionalShaft SealMechanical Seal Standard, Gland Packing optionalOperating Data Flow Rate(Q)2-1100 cbm/hHead(H)2-150mSpeed1450~2900 rpm (50HZ), 1750~3500 rpm (60HZ)Temperature-10 Celsius to 105 Celsius Working Pressure 10 Bar standard, 16 Bar standard on requestApplications 1General purpose pumping2HVAC and Cooling Tower3Fire Protection and Fire Fighting4Water circulation5Liquid transfer6Irrigation7Heating, ventilation and air-conditioning8Booster service