China Intelligent PIR Mw Complex Ceiling Mount Detector

Intelligent PIR and Mw Complex Ceiling Mount Detector (DT-6360STC)
Specification:
Honeywell's microcontroller-based, ceiling mount DUAL TEC Motion Sensor provides all of the advantages of DUAL TEC motion sensor accuracy and reliability in a convenient ceiling mount design.
Features
Microwave Advanced Processing (MAP)
Incoming microwave and PIR signals are constantly monitored and individually qualified for intrusion characteristics. The timing and sequence of each of these signals must be qualified by MAP settings to specific environments, allowing for optimum catch performance and false alarm immunity.
Microwave/PIR Technology
The use of dual technology provides the best detection available while virtually eliminating false alarms and costly service calls.
Built-in Diagnostics and Supervision
Allows trouble conditions to be quickly identified, diagnosed and corrected.
Ceiling Mount Design
360° field-of-view, mounting height from 8' to 16' (2.4m to 4.9m), install as recessed or surface mount.
Microcontroller-initiated Self-tests
Microcontroller automatically initiates self-tests at power-up, trouble conditions and programmed intervals.
Trouble Output
After a trouble is confirmed with a self-test, the trouble output can be used to annunciate the trouble condition.
Full Supervision Microwave/PIR
- Patented INFORMER® circuit constantly monitors microwave and PIR against blockage and misapplication.
- Independent circuit supervises both microwave and PIR against failure; at a loss of signal, microcontroller initiates self-test and unit switches automatically to single technology operation.
Mounting
Surface or flush mount on ceilings (flush mount kit included); maximum standard range obtained at 11' (3.4m). PIR mirror assembly included for installation on 12' to 16' (3.7m to 4.9m) ceilings.

ModelDT-6360STC Physical Dimensions
White, high impact, ABS plastic housing5.0" H x 5.0" W x 2 1/2" D (13cm x 13cm x 6cm) Weight 14 oz (397 g) Power Requirements
10 - 12.9 VDC40mA, 12 VDC typical Trouble Output Open collector: voltage between collector and emitter (Vce) is 0.3V @ 50mA Alarm Relay Energized Form C: (N.O./N.C.) reed relay rated 125mA at 25VDCCommand Output Self-test initiateActive:0 - 1.5V (low)Inactive:6 - V+ (high)impedance110K (minimum)Microwave Frequencies Center band 10.525 GHz (USA)Tamper Switch Ceiling and cover tamper switches; Form A (N.C.) switch rated 25mA, 30VDCOperating Temperature 32° - 120° F (0° - 49° C); 5% to 95% relative humidity, noncondensingRFI Immunity 30 Vm, from 10 MHz - 1000 MHzPIR White Light Immunity 900 LUXDetection Range 50' (15m) diameter, 25' (7.6m) radiusPIR Fields of View8'-11' mirror assembly (three 360° fields) Long range: 36 Intermediate: 24 Lower: 16 Look-down: 112'-16' mirror assembly (two 360° fields) Long range: 40 Intermediate: 20 Look-down: 1Sensitivity 2-4 steps within field of viewApprovals/Listings FCC certified, UL listed, DTI approved, CE

Picture:

about us:
SHENZHEN TAIAN ELECTRonICS Co., Ltd., is an Exporter and Wholesaler for Security Products in China. Our company specializes in PIR sensor, motion ,outdoor sensors ,sirens, alarm panels, GSM series and smokes for home safety and intruder Security alarm systems. Our products are suitable for use in Control center (report to Police), Garden, Bank, and all of the Commercial, Industrial and Civil buildings. For more information, see our products section. Welcome to view our website to know more about us. TAIAN is always looking for friendly cooperation with customers all over the world. We can be your best supplier with wide range of Security Products. Welcome to contact us for OEM & ODM service!