China LFP Battery 12V60ah Lithium Battery Lithium Iron Phosphate Battery Pack

Good performance under high and low temperature;Good safety performance;Good cycle life time;No pollution during manufacture.

Item

Specification

Remark

Rated capacity

60Ah

0.2Crate discharge capacity

Minimum capacity

60Ah

Internal impedance

≤1.2mΩ

Nominal voltage

3.2V

Cell weight

2.0±0.1KG

Standard discharge

conditions

Constant current

30A

End-of-charge voltage

2.8V

Standard chargemethod

Constant current

15A

Charge voltage

3.55V

Fast charge method

Constant current

60A

Charge voltage

3.55V

Max continuous discharge current

180A

Cycle life

3000 cycles

80% DOD

Operating temperature

Semiconductor Charging ambient

temperature

0~45°C

Discharging ambient

temperature

-25~65°C

Storage temperature

0~45°C

Appearance

Without break,

distortion, contamination,

leakage.

Basic Performance

(1)Output with high efficiency: Standard discharge current is 0.3C-0.8C, instant impulse discharge current is 10C for 10 seconds.

(2)Good performance under high temperature, it could work under65°Ctemperature.The battery structure is safe and good.

(3)Good performance under low temperature.discharge capacity decreases to over 78% under0°Cand discharge capacity decreases to over 70% under-20°C.

(4)Good safety performance:When the pressure inside the battery is too large, the one-way safety valve will release gas and heat to make sure battery perform well. When the internal pressure reaches a certain level, the valve will be open immediately which can prSignal Filter otect the battery from burning and explosion.

(5)Good cycle life time, the discharge capacity is still over 80% after 3000 cycle times of single cell(80%DOD).

(6) It can fast charging. It could be charged to 80% within 20 minutes and charged full with 2-3h.

(7) Low cost.

(8) No pollution during manufacture and usage.

Matters needing attention

(1) Please check if spare parts are completed when open the package and read the operation manual carefully.

(2) Do not make the battery Short Circuit,do not over charge anAntenna d discharge.

(3) Please charge the new battery to full capacity before discharge for the first use.

(4) The battery pack is fixed with plate and strip before delivery, do not disassemble the plate and strip when using the battery.

(5) Checking the voltage of battery, normally it is 3.2V-3.3V.

(6) Fix BMS for battery pack and protect single cell to avoid over charge and over-discharge.

(7) Rivet or screw is used for battery connector.

(8) Please use copper part to connect battery packs and fix with hydraulic pressure plier. We could also provide the relevantconnection which fixed with screws.

(9) The charger used should be approved by our company in order to match with our lithium batteries.

(10) It will shorten battery cycle lifetime and damage battery due to overcharge and over-discharge if not do according to the above . It won't be within our company warranty.

Requirement for safety assuranceConveyor & Parts

For the sake of safety assurance, please discuss the equipment design, its system and protection circuit of Lithium-ion cell advance. And consult about the high rate current, rapid charge and special application in the same way.

Service line: +86-400-884-7799