China Marine Equipment Soft Boat Step Wooden Pilot Ladder Liferaft Embarkation Ladder

Marine Equipment soft boat step Wooden pilot ladder and liferaft embarkation ladder
ship Embarkation and ship pilot ladder are one type of rope ladder, usually made by hard wood and used for embarking and disembarking pilots and crew. It is an important tool for marine safety. With spreaders step (Preventer Step) and magnet, pilot ladder and embarkation ladder could work safety under kinds of sea conditions
Wooden Embarkation and ship pilot ladder Standard: Requirements of the ZC Regulations for the statutory surveys of ships and offshore installations
Product Inspection Standard: Requirements of the ZC Regulations for the statutory surveys of ships and offshore installations and International Marine Anti-collision Regulation(1972),1996 Amendments to the SOLAS1974, and CB/T3142-94,CB/T428-93

Namemm Board Size (mm)
Orifice
MaterialShort BoardLong Board
Pilots Rope Ladder525x115x30
flat board1800x115x30Φ25mm willow525x115x30∼38
525x115x30∼60
slotting board
Rope Ladder525x115x30
flat board1800x115x28525x115x30∼38
525x115x30∼60
slotting board
Product Description:
1. wooden boat pilot ladders Step material: hard wood
2. The Max qty of step: 30steps
3. Equipped in the embarking place of the life raft and boat, for pilots to board and leave the vessels.
4. In accordance with the 2000 Amendments to SOLAS 1974 and LSA.
5. The lowest 4 steps are rubber plates with steel lining;
6. The count-down fifth plate is spreader step, and there are 8 short boards between two neighboring spreader steps.
7. The distance between two neighboring steps is 330+/-20mm
Ship pilot ladder lifeboat embarkation ladder Parts
Made up of Rubber step (the last four steps), Wood step, Spreader (Preventer Step), Step fixing piece, rope.
Rope:
Ropes should be mold-resistant manila or heat-treated polyester rope with polypropylene core and should not be covered. Ropes shall be of a diameter which is no less than 57mm in circumference, and have a braking strength more than 24KN.
Steps:
The distance of inner edge of side ropes should be more than 400mm, the width of step is no less than 115mm, and thickness no less than 25mm. The steps should be non-slip, hard wood steps without knot and equally spaced at 330±20mm.
Rubber Step:
The bottom 4 steps may be made f resilient synthetic raw material or rubber if it is of sufficient strength and stiffness. Rubber steps should be of the same required dimensions as the wooden steps.
Spreader:
Spreader shall have the same specifications as normal steps, but length of spreader shall not be less than 1.8 meters.
Step Fixing Piece:
Must be wood or plastic
Fastening Hardware:
Fastening hardware for rope and steps must be corrosion resistant, or made of similar material treated corrosion resistance.