China Offer Inner-Climbing Tower Crane Second Hor New

Inner climbing tower crane ----We successfully developed this new kind of crane which is used inside buildings. It can greatly save your cost by saving mast sections.
Product Description
Inner Climbing Tower Crane has three attached frames, from down to up respectively are load bearing attached frame, antirotation attached frame and transition attached frame. The distance between two adjacent attached frames is nine to twelve meters, three attached frames all are on the girder Steel, and they connect with the girder Steel by bolts. The girder Steel is put on the concrete beam of core tube elevator hoistway, and they connect with each other by bolts to assure that connection of girder steel and building structure is reliable. All attached frames can be dismantled to assure the cycle use and function conversion. Load bearing attached frame is mainly to bear the vertical-down acting force generating in every kind of working condition. Antirotation attached frame is mainly to bear the torsional moment and bending moment generating in every kind of working condition, and serve as the climbing pathway in the process of climbing and at last it serves as antirotation attached frame. Tower crane only uses load bearing attached frame and antirotation attached frame to fix tower body in normal working condition, but before climbing we need to install the third attached frame to serve as transition attached frame, so as to assure the reliability of climbing track. Climbing height is the distance between load bearing attached frame and antirotation attached frame.
1:Fix two pieces of ready-made girder steel to concrete beam of building's core tube by sixteen bolts, then install strengthen attached frame on the girder steel and adjust the gap between guide pulley and tower body(generally two to five millimeters). Note: The armoured concrete beam of building must be designed by designing institute and up to the requirement of bearing capacity.
2:Fix the jib in the direction of vertical to climbing crossbeam and adjust the range of trolley to make the barycenter of tower crane pass jacking oil cylinder.
3:Put the claw hand of inner climbing jacking crossbeam on inner climbing pathway, raise the tower body up, and put claw hand of inner climbing base section on vertical position. Figure (1); Put the claw hand of inner climbing base section level, limiting tower body sliding down, draw back jacking oil cylinder.
Figure (2); After jacking oil cylinder is drawn back, put the claw hand of inner climbing jacking beam level, and put the claw hand of inner climbing base section vertical.
Figure (3); Repeat it again and again to make tower body rise as desired requirement.
Figure (4). When tower crane rises to desired height, lay two load bearing support square beams under the channel steel of inner climbing base section, let them bear the weight of tower crane.
Product specification:
1. The products type contain: Inner Climbing Model: QTG20NP
Lifting performance table table 1 2 multiplying power
Range m 2.5-11.68 12 13 14 15 16 17 18 19
Lifting weight t 2000 1937 1766 1621 1496 1388 1293 1209 1134
Range m 20 21 22 23 24 25 26 27 28
Lifting weight t 1067 1007 952 903 857 816 777 742 709
Range m 29 30
Lifting weight t 678 650
2. Technical performance table
Rated lifting moment KN M 200
Max. Lifting weight t 2
Work range m 2.5-30
Lifting height Independent 19.8
Lifting speed 2 multiplying power m/min 45/22/4.7
Slewing speed r/min 0.76/0.38
Luffing speed m/min 22.5
Jacking speed
Min. Steady falling speed <7
Size base m 3.847x 3.847
Whole machine Height Independent 19.8 Attached
Lifting arm end to tower center
Balance arm end to tower center 8.4
Balance weight 3.470
Motor total power kw 15.6
Permitted work temperature -20~+40
More details about these products, please contact me directly. I can provide you the detailed Configuration Sheet and other necessary technical info you need.