China Pneumatic Jack for Lifting Car for 3ton Use

A new type of lifting device that uses compressed gas as power, liquid pressurization and telescopic pneumatic cylinder. It has the characteristics of exquisite design, small size, light weight, easy operation, time saving, labor saving, and large tonnage. It is widely used for mobility lifting, especially for the repair industry of transportation industry such as automobiles and tractors.
In the past, people used ordinary hand pressure jacks to have many deficiencies. This jack fundamentally solved the inadequacies of ordinary jacks.
Labor-saving: Labor intensity is only to push the jack to the right working position, and the switch can be used to achieve the purpose of lifting.
Time saving: When the general transport vehicle carries 120 tons, the wheel can be raised to a suitable height in about 2 minutes.
Safety: Instead of climbing to work under the car, the staff can control the switch outside the car body to achieve the purpose of lifting, and avoid the danger of personnel.
Clean: repairing the car itself is a dirty job, this product overcomes the dirty image of the staff in the wind, rain, snow days.
Cost saving: This product has good durability and is 20 times of ordinary jack. The company maintains the product for lifelong maintenance and three bags, which reduces your repair cost.
1. Adjust the grip to 90° when not in use and save floor space.
2. When moving the jack, adjust the grip to 45°, and the person can push and pull the jack.
3. When the working position is aligned, adjust the grip to the horizontal direction, and adjust the position of the jack back and forth.
4. Connect the air source when lifting, the air pump should be above 0.6 cubic meters, and the pipe diameter should be above 8mm.
5. Hold the knife lever lever and adjust the angle of the grip.
6. Adjust the three gear positions on the switch as needed.
7. The long top should be placed every time to avoid damage to the cylinder caused by direct contact between the body and the cylinder.
8. Filling port should be filled with aviation air pressure oil. The amount of fuel should be equal to the level of the fuel tank when the jack is flat.
It uses compressed air as the power to drive the air pump to work, pumping the high-pressure oil into the pneumatic jack, so that the jack can be lifted to achieve the purpose of lifting. The pneumatic jack is lifted and lowered by controlling the oil return valve. The mechanism is divided into five parts: air pressure jack, air pump, wheel frame, pneumatic control and traction. The pneumatic jack part and the air pump part are of split structure. The valve plate is connected by single air pipe bolt type, the upper handle tube of the traction part and the lower part. The stem tube is detachable. It has the characteristics of exquisite design, small size, light weight, easy operation, time saving, labor saving, large lifting tonnage, etc. It is widely used for mobility lifting, especially suitable for the repair industry of transportation industry such as automobile and tractor.

lift weight3000kgs air pressure0.5-1mpaMin height150mm Max height400mm Inlet sizeG 1/4lift time25swork temperature-30 to 50degreeNet weight20Kg.Gross weight22Kg. package size1530*330*330mmVacuum valveIncluded, which could facilitate the going down speed.Pull rodFoldable Work RangeMainly for carsFunction Mainly for car repair and body shops.