China Shantui Sm200m-3 Road Milling Machine

Shantui SM200M-3 high quality road milling machine

Product Features
Shantui SM100MT-3 road milling machine is one 1m-wide wheeled milling machine mainly applied for the removal and stripping of pavement diseases on urban roads and asphalt roads in various grades as well as for the small-scale operations of expressways, airport runways, and ports and harbors and the texturing of cement roads.With milling width at 1,000mm, maximum milling depth at 300mm, front wheel steering mode, and lifting and lowering mode of two rear pillars, its milling drum is mechanically driven (namely clutch + belt + reducer) and its traveling system adopts fully-hydraulic four-wheel drive. The conveyance mode of one-stage belt rear discharge is adopted. The right rear pillar can be rotated to the front of the milling drum to ease the welt operations. The electric system adopts CAN bus network control technology, with fault diagnostic and alarm system. The standard automatic leveling system is fitted for whole machine.With the technologic orientation and configuration equivalent with German Wirtgen W100, this product is one high-end model among the domestic like products.
Transmission System
1. Using energy-saving technologies such as automatic engine idle speed, the whole machine has better fuel economy, low discharge load and high work efficiency.
2. The milling drum is driven by the mechanical belt and the hydraulic belt of the transmission belt is tensioned. The transmission efficiency is high, which effectively reduces the impact of the operation and makes the power transmission smooth and reliable.
Walking System
1. The walking system is fully hydraulic four-wheel drive, with strong climbing ability, and it is safer to transport the board above and below.
2. The working pressure of the walking system can reach 375bar or more, and the traction ability is strong.
3. The walking system has a forced shunt function to prevent slippage.
4. The driving speed is up to 8km/h.
5. The right rear pillar can be rotated by 180° for the welt.
Milling Rotor Assembly
1. The new milling rotor is equipped with a high-wearing tool holder with a milling depth of up to 300mm and a high working capacity.
2. The milling rotor is equipped with a powerful sprinkler system.
3. Hydraulic lifting of the side plates on both sides;
4. Optional economical and fine milling drums to meet various construction requirements
Easy Maintenance
1. Structural parts inherit the excellent quality of Shantui's mature products.
2. The large opening design of the hood and side door provides ample space for maintenance.
3. The core electrical and hydraulic components are imported, the quality is stable and reliable, and the reliability is extremel high.
4. Oil filter, grease nozzle and other external, hanging installation, maintenance and replacement is convenient.
Product Parameters

Milling width (mm)

2000

Milling depth (mm)

0~320

Milling drum tool tip distance (mm)

15

Number of milling cutters

162

Engine model

QSX15-C600

Rated power/rated speed (KW/rpm)

447/2100

Displacement (L)

15

Emission

Euro 3

Driving speed (km/h)

0-5

Working speed (m/min)

0~30

Machine weight (kg)

29700

Working weight (kg)

32000

Fuel tank volume (L)

1280

Hydraulic tank volume (L)

335

Water tank volume (L)

3540

Voltage (V)

24

Tire type

Solid rubber tire

Feed belt width (mm)

500

Feeder swing angle (right / left) (°)

25 /-20

Maximum discharge height (short belt, optional) (mm)

4595