China Table Type Pneumatic Hot Melt Equipment

Table Type Pneumatic Hot Melt Equipment Model:BY-3025RR(QD)ItemDetailed InformationEquipment IntroductionThis equipment has been applied to the hot melt riveting of shell products, the equipment can be welded from two different directions at the same time.The total number of riveting points is 4, and the temperature is controlled by region. 10 sets of welding programs can be pre-stored, and the data interface can run in tandem with the production line. Japan MISUSI original heating device. Hot plate temperature control, with self-test, closed-loop control, multi-point independent temperature control, temperature control accuracy up to ±2 degrees.Equipped with man-machine interface and Chinese and English bilingual interface operation.The cooling system is air-cooled by blowing air.Production cycle time25S-40S.Equipment FeaturesMan-Machine EngineeringSafety: the machine is equipped with protective grating and scald warning safety baffle.Permission management: device setting administrator and operator permissions.The work table height is 750MM(Sitting position)The quipment starting mode: The equipment is started by pushing two starting buttons together with two hands.Equipment capability/Quality traceabilityThe device has the protection function of misoperation(the machine will not work if the machine is not operated according to the standard operation procedures).Production records:The equipment can meet customer requirements for recording and storage of product capacity.Alarm failure and code recording:The equipment automatically displays the alarm fault code and records it automaticallyMan-machine interface - visual information of man-machine interface includes current operation steps, alarm information and solutions.IMS interactive function: support Ethernet communication. The equipment has the function of QR Code scanning and identification. The data of hot plate temperature, displacement and time can be recorded and sent to the company's IMS system. (This function is customized according to customer requirements.)Electrical layout/SafetyThe equipment is equipped with tooling identification sensor. If the tooling model is wrong, the system will alarm and lock the equipment.Locking function: in case of equipment failure or clamp installation error, the product is locked to the corresponding station (it needs to be unlocked by the designated personnel).Equipment alarm: when the equipment fails, the man-machine interface displays alarm information, and the control system locks the machine.Control system voltage DC24V.I/O- each station has a 10% I/O allowance for future expansion.Technical ParametersEquipment demension(L)460MM*(W)400MM*(H)900MM.Maximum allowable die size of equipment(L)300MM*(W250MM*(H)250MM.Electric power requiement: 3 phases 380V 50Hz(If there are special requirements, customer confirmation is required.).The outlet pressure of the air compressor: 4Kg/cm2-6Kg/cm2(0.4MPA-0.6MPA).Adaptable to ambient temperature: -5ºC~40ºCAdaptalbe to humidity : 20%~80%The noise of the transmission part shall not exceed 70 db.