China Vacuum Emulsifying Machine

Vacuum Emulsifying Machine
Working principle
The LTZR-600 Vacuum Emulsifying Mixer is composed of main pot(emulsifying pot),a water phase pot and an oil phase pot, vacuum unit, up-and down system, electrical control system and the motor frame etc.
The main pot is composed of the cut-off mixing pot, cut-off mixer unit, circulating system and the stirring system etc.
The materials are sucked into emulsifying pot by transportation pipe under the vacuum state, or it also can be put from the feed inlet.
The material are stirred by both the center blade and side scraper, which works on the inner surface of pot keeping stirring materials from being stuck onto the wall. In the process of blade-stirring, the materials are continuously crushed, pressed, fold. Then the material is sent to the cut-off mixing unit where they are again cut off, broken and stirring by the strong interaction between running cutting wheel and cutting sheath. The materials are finally crushed into small pellets of 200um~2um. Besides, because of the vacuum in emulsifying pot, the bubbles generated during stirring and mixing process are sucked out from material. The ex-circulating system can make the homogenizing more strong. The material within the pot can be give off only under the state of change direction of the control valves.
The temp controller on operation panel can adjust the temp of the homogenizer pot; The homogenizer stirring and the blade stirring cab be used simultaneously or dividedly; The homogenizer stirring time can be set by the custom according to the different material. After finished the whole procession please rise the pot cover for the clearing.
Main Technical Data:

ManufacturerChina LTPM Group Co., LTDPN600L vacuum emulsifying mixerCapacityDesign volume: 600L, working capacity:600LKettle CoverLiquid(particle)inlet, sunk material inlet, air inlet with filter, inspect light and sight glass, vacuum port, pressure meter(1 to -0.1 bar), pressure clampMixing potMaterialInner layer: SUS316L thickness: 3mmMiddle layer: SUS304 thickness: 2mmOutside layer: SUS304 thickness:2mmconfigurationBottom material exhaust, size: 1.5"Temp. sensor (0-199ºC)Electrical heating: 24kw, cooling water inletStirring systemHomogenizer1.Material: SUS316L; standard homogenizer
2. Power: 24kw/380/50Hz; RPM: 0--2800R/MinStirring scrap and middle stirringMaterial: SUS316L,Scrap material: PTFE1. Stirring scrap and middle stirring use the same motor
2,Power:0.75 kw/380V/50Hz;RPM:0~86r/min(Frequency control)
3. Stirring scrap and middle stirring rotating the opposite directionSafety: 1. During stirring, the cover can not open, 2. Cover lift can not stirring.Vacuum system1. Vacuum pump: water recycle, power 5.5kw/380V/50Hz
2. With pressure sensor (during vacuum condition, hydraulic can not open)Heating methodJacket electrical heatingExhaust methodElectric doom and bottom discharge or positive pressure discharge materialPressurePressure in the pot during working: -0.090 Mpa; Jacket working pressure:0.2 MpaControl boxSUS304 , 1.2mm thicknessDimension3850mmx2800mmx2700~3950 mmShelf is SS, platform with raised platform and SS guardrailSpare partsOne year spare parts and toolsGuaranteeOne yearUsing lifeMore than 15 years

Oil potDesign volume450LWorking capacity450LStirring power2.2kwStirring speed1400 RPMHeating power20 Kw
Water potDesign volume450LWorking capacity450LStirring power2.2kwStirring speed1400 RPMHeating power20 Kw