China Video Power Control 3 in 1 Analog Dome Camera Surge Protector

video power control 3 in 1 Analog Dome Camera Surge Protector
Model: OP-SV3/24

APPLICATIONS:
Designed to protect monitor equipments (Power, Date Control, Video), widely applied in bank monitor & safe
guard system.
Monitor equipment for school, enterprise, road etc. security and protection.FEATURES:
Multi. Protection circuits, Gas-Tube+ TVS technology
Dual protection in Common module and different module
3 in 1 protection
TVS array technology, low capacitance
Multi-Strike CapabilityTECHNICAL PARAMETER: ModelOP-SV3/24Electrical ParameterMax. continuous operating voltage Uc12VNominal discharge current(8/20µs)In3kAMax. discharge current (8/20µs)Imax10kALimiting voltage (10/700µs) Up Line-line40VLine-ground500VAdapt transmission rate30MbpsInsertion loss0.5dBResponse time tA1nsImpedance75 Interface formBNC, 2P Compression plug
Working voltage30V ACMax. continuous operating voltage24V ACNominal discharge current (8/20µs)5kAMax. discharge current (8/20µs)10kAProtection level (8/20µs) 1000VInterface form2P Compression plugMechanical characteristics
Dimension100(L) x70(W) x44(H)mmWeight per unit200gIP CodeIP20Working conditionsTemperature: -40 to 80ºC,
Relative humidity: ≤95%Standards complianceCE, FCC, RoHS

INSTALLATION AND MAINTENANCE

a) The SPD should be connected in series between the protected device and the signal/power transmission channel.
b) The input terminal (IN) of the SPD should connect to the signal transmission channel, and the output terminal (OUT) of the SPD should connect to the protected device.
c) Connect grounding wire of the SPD to grounding bus-bar of the lightning protection system of the room or building.
d)No special duty needs to be carried out for maintenance. When problem arises and the SPD is suspected, check the system with SPD taken out of circuit. Should system recover, the SPD shall be regarded as a damaged unit and must be replaced immediately