Double Girder Overhead Magnet Crane

Double Girder Overhead Magnet Crane
Application:
This crane is a special product equipped with electromagnetic carrier beam that used to lift iron or steel plates, pipes and so on. It consists of bridge, crane travelling mechanism, trolley, electric equipment and lifting beam. Both travelling mechanism and trolley motors are special motors for cranes, large starting torque and loading capacity.
The electromagnetic beam can be taken down from the hook or desinged as fix hanger. The beam length can be designed as requirements. The beam can be parallel of plumbing with crane girders depending on transporting environment.
For higher application requirements, extractable and 360 degree electromagnetic beam suspending system can be provided. Double Girder Overhead Magnet Crane 40 tonThe number of rectangular magnets below spreader beam is considered to the size of long billet need to be lifted.
Maximum back up time of battery for magnets shall have of 30 minutes.
The magnets is suitable for temperature under 200 deg C.
Full length chequered plate platform at both sides. The minimum width of platform as request.
Load cell for over load protection of hoist on request.
Alarm bell provided for safety purpose.
Canopy is provided for electrical equipments for weather protection outdoor. Rail anchoring & storm anchoring are all on request. Double Girder Overhead Magnet Crane 40 ton
The General arrangement drawing with load data & Quality Assurance Plan will be submitted with offer
Initial fill of lubricants, gear box oil etc., supplied along with the crane.Performance feature:
The carrier-beam is cross structure, which is reliable and has good safety features, and has a certain function of preventing swinging. The lower part of the carrier-beam can bring special lifting appliances, such as magnetic chuck and tongs, etc.
Safety Feature:
Main lifting motor with thermal protection,
Overload protection,
Rubber buffers Double Girder Overhead Magnet Crane 40 ton
Protective earthing,
Crane switch and travel end switch,
Emergency switch can stop all movement when any dangerous happened,
Sub-assemblies characteristic are tested before assembly.
All cranes must be pre-assembled and tested before leaving factory and offer the certification of test.Used in:
Ship Yards
metal Working
Service Centers
Cutting Table Operations
Shipping and Receiving
Fabricating Areas
Welding DepartmentsCustomization
We can design cranes meets your need, it would be very kind of you to give us the data needed listed below:
1. Lifting capacity.
2. Span length. (cantilever length)
3. Lifting height. (hook center to ground)
4. Power supply: Voltage.
5. Do you need rails? How long is the crane traveling distance?
6. Working condition: Which material to lift? Temprature?
7. Would be better if you have drawings of your plant.ITERM QC type grab craneLifting Capacityt5101620Spanmto 31.5Working ClassA6SpeedHoistm
/
min40.140.741.848.6Trolley44.645.641.848.6Crane93.786.476898987.387.3Motorhoist closingKwYZR225M-8/22*2YZR280S-10/37*2YZR315M-10/75*2YZR355M-10/90*2trolleyYZR132M 2 -9/3.7YZR160M 2 -6/7.5*2YZR160M 2 -6/7.5craneYZR160M 1 -5.5*2YZR160M 2 -6/7.5*2YZR160M 2 -6/7.5*2YZR160L-6/11*2YZR160L-6/11*2YZR180L-8/11*2YZR180L-8/11*2YZR200L-8/15*2Power3-phrase 50HZ 220V~480V according to your requirementsWorking environmentThe temperature of working environment is -10~+60° C;
The relative humidity is no more than 50% when the temperature is +40° C;