Fa-V13 High Definition OBD-II Hud Head up Display for Car safety

FA-V13 High Definition OBD-II HUD Head Up Display for Car Safty1, Introduction of the product:
The purpose of this product is to avoid the accident caused by the driver looking down at the instrument display while driving, and to keep the driver in the best driving state. This is a new high-tech product of virtual imaging, which mainly displays the engine RPM and speed of the vehicle. The imaging distance is 1.5 meters and the imaging size is 4.5 inches.2, Supported OBD-II Protocols:
SAE J1850 PWM(41.6 Kbaud)
SAE J1850 VPW(10.4 Kbaud)
ISO 9141-2(5 baud init,10.4 Kbaud)
ISO 14230-4 KWP(5 baud init,10.4 Kbaud)
ISO 14230-4 KWP(fast init,10.4 Kbaud)
ISO 15765-4 CAN(11bit ID,500 Kbaud)
ISO 15765-4 CAN(29bit ID,500 Kbaud)
ISO 15765-4 CAN(11bit ID,2500 Kbaud)
ISO 15765-4 CAN(29bit ID,250 Kbaud)3, Product Features:
Image rendering: only vehicle speed and engine RPM are displayed.
The synthetic imager uses manual adjustment to adjust the angle of the synthetic image so as to achieve the best image effect.
The light sensitivity has a standard value, allowing users to adjust the brightness to increase or decrease by 20%.
It is not dazzling during driving.
HD display.
Lossless installation.
Plug and play.4, Main Components:
HUD main machine
Conversion cable
OBD adapter
Adjusting bracket
Bracket pad
User manual
Color box5, Technical Parameters:
Main control chip: R8F5SA6
Imaging range: 1.5m
Imaging size: 4.5 inches
Working voltage: DC 9-16V
Working current: 80mA
Operating temperature: -20-65ºC
Storage temperature: -30-80ºC
Product dimension: 116*74*25mm6, Installation Guide:
Match and adjust gaskets and brackets and so on according to the difference requirement of driver and vehicle type, the purpose is to make the driver feel the best. When the vehicle is under flameout state, connect and link all components, connect the 5PIN end of the conversion cable to the HUD, and the OBD end to the OBD socket of the car. Tidy the cable if it is necessary.Fix the matched gasket on the HUD, and then fix it in the right position on the car. Ignite the car and start to adjust the angle of the lens, try to get best display effect of the HUD and then you can start to use it.