Flow Switch of Metal Material

Our flow switches are designed to prevent catastrophic failure of the torchand ports in the event of low coolant flow. The typical flow rate are 1 ti 1.50 gallons minute.At the same time, our level and temperature switches are used in the collant reservoirs, made of plastic or metal tank for holding the torch coolant.Characteristic
Parts name: Material and parameter
Farts:
Housing Brass C37700
Piston PVC or PBT
Spring Stainless steel
Retaining rings Stainless steel SUS 304
Operating pressure 300 PSI max
Temperature range -40~125deg. C
Carry current 1.5A
Switch current: 1.0Amax
Switch voltage: 300Vac, 250Vdc
Power rating: 70VA
Lead wire AWG 22, to 18, 300mm length, UL1430, free lead wire
Flow range: 0.75L~8.0L/min
Set point Accurancy: 10% max
Set point Differentive: 15%
Repeatability: 2% max
Mounting: Mounting orientation (Horizontal or vertical) as signal of flow direction Mounting orientation
Mounting thread: FNPT. 3/4",
Adequate filtration and sealing Procedures should be used when mounting in flow line
ItemTechnical ParameterCompatibleClean fluidAccuracy±3% of readingRepeatability±0.5% of readingNominal Flow RatesFrom 0.1 to 1.0 or 0.8 to 10 gpmTemperature and Pressure16 bar @ 20ºCRotorPP or client requiredBodyPP or client requiredBearings and ShaftCeramic or SUS304 1/2"1/4"3/8"flexible tubingInput Power5 to 24 VDC @ 1.0mA maxOutput SignalOpen collector NPN transistor sinking a maximum of 30mA