Haitel Manufacture machine make disposable non woven medical face mask machine

Product Description

HTL-120 Full Automatic Mask Production Line

I. Machine introduction:

HTL-120 Flat mask one drag two outer ear band machine is a fully automatic high-speed flat ear band mask production line newly developed by Jiangsu Haitel Machinery Co., Ltd, Ultrasonic fusion, molding, cutting and other full-process automation, complete the entire production process from the raw material of the coil to the finished mask.

II. Equipment Product Features:

1. The entire equipment is fully automated.

2. The whole machine adopts aluminum alloy structure, which is beautiful and solid without rust.

3. Computer PLC programming control, servo drive, high degree of automation.

4. Automatic tension control of raw materials to ensure that the tension of raw materials is balanced.

5, photoelectric (optical fiber) detection of raw materials to avoid errors and reduce waste.

6, using multiple sets of pneumatic components to achieve precise control.

III. Technical Parameters:

Equipment size

6150mm (L) x 3720mm (W) x 1950mm (H)

(excluding receiving line)

Appearance colorInternational standard warm gray 1C (DB standard color), according to this standard without special instructionsEquipment weight≤5000kg, ground load ≤500KG / m²Working powerEquipment 220VAC ±5 %, 50HZ, rated power about 9KWCompressed air0.5 ~0.7 MPa, the use flow rate is about 300L / minOperating environmentTemperature 10 ~ 35 ℃, humidity 5-35% HR, no flammable or corrosive gas Body, no dust (cleanliness no less than 100,000)temperature 10 ~ 35 ℃, humidity 5-35% HR, no flammable or corrosive gas Body, no dust (cleanliness no less than 100,000)Production efficiency90-130 pcs/minEquipment production pass rate99% (except when the incoming materials do not meet the requirements or the employees' improper operation is excluded)Equipment failure rate2% (refers to the failure caused by the equipment itself)

IV. Introduction of Raw Material Selection

Common medical masks: It consists of three layers of non-woven fabric, the inner layer is ordinary non-woven fabric; the outer layer is non-woven fabric with waterproof treatment, which is mainly used to isolate the liquid sprayed by patients; Electret-treated polypropylene melt blown nonwoven fabric.

ATTENTION:

After production, it is sterilized by ethylene oxide and left to stand for 7 days. It is volatile and toxic after being sealed.

Company Information

Certifications

Our Services

Packaging & Shipping

Welcome to visit our factory!!!