IP2X Test Probe B Jointed Test Finger

Introduction and application:
IP2X test probe B jointed Test Fingeris intended to verify the basic protectiion against access to hazardous parts. It's also used to verify the protection against access with the back of the hand. It isthe neccessary tool to proceed protecting electric shock test of household and similar electrical appliances.Test standard:
IEC60065, IEC 60335-1, IEC 60529, IEC60884-1, IEC60950, IEC61032, IEC69745-1Main data:
1, Knurled Finger Diameter:12mm
2, Knurled Finger Length :80mm
3, Baffle Plate Diameter :50mm
4, Baffle Plate Length : 100mm
Application:
1.The joint parts of the test finger cannot touch the live parts or hazardous parts, and the 50mm-20mm Baffle Plate cannot enter.
2.In the test requirements of preventing from approaching to the hazardous parts, the probe B test probe needs to with a 10±3N thrust. The product without force should be used with push-pull dynamometers.
3.In the test of against electric shock, wiring ,configuration and power and indicating device are needed. Turn on the power of the tested sample, and exert the corresponding force to determine whether the grounding line are connected (3 inserts).
4.Both joints shall permit movement in the same plane and the same direction through an angle of 90° with a 0° to +10° tolerance
This probe is intended to verify the basic protection against access to hazardous parts. It is also used to verify the protection against access with a finger.
Tolerance on dimensions when no specific tolerance is given:
- on angles: 0
−10°
- on linear dimensions: up to 25 mm: 0
− 0,05 mm; over 25 mm: ± 0,2 mm.
Note : The Test Probe is precision stainless steel products, take up and put down slightly when using, and pay attention to maintenance.
Except theIP2X test probe B jointed Test Finger, we also can supply other test equipments, any be interested or needed, please feel free to contact MS Angela Cheng for more help.