China 3kw Automatic Conveyor Front Leg Skinning Slaughtering Equipment Agricultural Machinery

3kw Automatic Conveyor Front Leg Skinning Slaughtering Equipment agricultural machinery
The automatic conveyor mainly advances simultaneously with the automatic conveyor line of the hind legs, realizing balanced pre-stripping, cutting the sheep head, hanging the sheep's front hoof after cutting the hind legs, removing the shoulder, peeling, peeling, cutting the front limb, etc.
installtion and run test:
1) the machine can only leave the factory after strict inspection, debugging and normal operation before leaving the factory. But after leaving the factory may be due to transportation, loading and unloading and other factors caused by poor operation and other failures, so before installation must carry out a comprehensive inspection to ensure that all components are in good condition after installation;
2) the equipment should be installed in a reasonable position according to the technological requirements, and should be fitted with the bloodletting table and the hoist;
3) checking the belt tightness and adjusting if it is found to be abnormal;
4) adding lubricating oil to the rotating parts;
5) after installation, the test run is adopted to check whether the operation of each mechanism is stable or not. If no blocking or abnormal phenomenon is found after no-load operation, it can only be put into use.
the point of operation safety
1) the operator should first read the specification of v-type restricted conveyer, understand its structure, performance, safety regulations, etc.;
2) the user must establish the rules and regulations related to the equipment and the safety operation rules.
3) the operator should have the knowledge of mechanical and electrical operation and be healthy;
4) the operator should be trained on the job, familiar with the safe operation procedure, and hold the certificate for the post;
5) the operator should pay attention to the safety and do the protective measures well.
6) No load operation inspection should be carried out before each shift;
7) it is strictly prohibited to put hand or other things into the conveyor belt while the machine is working, in order to prevent injury to people or damage to machine
8) if the conveyer has abnormal working sound, it should stop and check immediately to prevent the machine from causing serious damage. The person is injured, and put up the sign prompt;
9) the machine must be cleaned and maintained at the time of stopping, and must confirm that the power supply has been cut off and put up a sign;
10) after working, shut off the machine and cut off the power supply;
Inspection, maintenance, maintenance and troubleshooting methods:
1) after installation and use of the machine, check whether the motor, bearing, drive shaft, passive shaft and conveyor belt are normal or not, often add lubricating oil to the lubricating parts, such as shaft sleeve, conveyer belt and so on, there is loosening phenomenon, should adjust in time;
2) at the same time, the fasteners should be strengthened regularly in order to reduce the looseness because the machine is in the state of load, jitter and vibration.
3) in addition to the usual maintenance, a major overhaul should be carried out after the production in the peak season every year, and the parts with serious wear should be replaced in time to prolong the service life of the machine.
4) after the equipment runs for a long time, some parts can not continue to be used because of serious wear and tear, so it should be replaced in time.