China GB T 8110 Er50-2 Carbon Steel TIG Welding Wire

GB/T 8110 ER50-2
AWS A5.18 ER70S-2
BS EN 1668-W 38 3 W2Ti
ISO 636-A-W 38 3 W2Ti
ISO 636-B-W 49 A 3 W2
Carbon Steel TIG Welding Wire
Introduction
It is TIG wires for 450 and 500MPa grade carbon steel. Good welding technical performance, all-position welding and beautiful welding performance. It has good crack resistance and higher low temperature impact toughness.
Application
It is mainly used for single pass welding of killed steel, semi-killed steel and rimming steel. No need gas protection at back of joint.
Chemical Composition

CMnSiSPCuTiAlZrf0.0351.140.530.0040.0110.200.130.080.08

Mechanical Properties

Tensile Strength Rm (MPa)Yield Strength Rel (MPa)Elongation A(%)-30°C Impact Value AKV (J)5504502685

Notes:Protection gas flow requirement: The welding current is 100-200A at air flow of 7-12L/min; It is 200-300A at air flow of 12-15L/min.The extension length of the tungsten electrode should be as short as possible relative to the nozzle, and the arc length should be 1-4mm (2-4mm for welding carbon steel; 1-3mm for low alloy steel and stainless steel welding)It adopts windproof measurement while wind speed is above 1.0m/s.Strictly remove grease, rust and moisture impurities while welding.Welding linear energy directly affects mechanical properties of welding seam metal and crack resistance performance, etc which should be paid more attention to.The above points are taken into reference. GB/T 8110 ER50-2