China Lorawan Remote Control Smart Automation Solution Gateway

1.1 Brief introduction:WE-GW-10 gateway is a full-duplex data communication industrial-grade outdoor gateway based on LoRaWAN protocol, which is of high-performance, low-power and wide range networking. It is waterproof and of wide voltage input to be the key equipment for building low-power WAN. It can support all kinds of equipments two-way wireless communication services, LoRaWAN, 2G/3G/4G wireless communication and 100M Ethernet wired communication. It can also meet the networking requirements of high-speed communication, low power consumption, and many nodes access. More importantly, this industrial-grade communication device can work stably in harsh environments so it is an ideal gateway to apply to smart lighting, smart city, smart community, smart bus station and other fields when supports frequency bands of CN470-510, US915, AU915, AS923, KR920, IN865.1.2 Features:

12V~36V wide voltage DC input

Follow LoRoWAN wireless transmission protocol to support transmission and reception of full-duplex LoRa communicationSupport multiple network access methods such as 2G/3G/4G and LANAdaptive data transfer rateOutput power up to 23dBmSensitivity dropped to -142.5dBmSupport 8 channels of concurrent, the number of accessible nodes is up to 2000The farthest transmission distance is 15Km (line of sight), 2Km (city distance)Supports various operating frequencies such as CN470MHz/US915MHz/EU868MHzEffective lightning protection grounding protection1.3 Performance parameters:

Communication parametersNotesOperating frequencyCN470MHz/US915MHz/EU868MHzTransmit power< 23dBmReceive sensitivity> -142.5dBmTransmission distanceCity: 2Km line of sight: 15KmAccess methodLAN, 2G/3G/4GData ProtocolUDP/TCP/MQTTLoRa antennaT-NC female interface4G antennaT-NC female interface

1.4 Hardware parameters

Hardware parametersNotesSupply voltage12V~36V Recommended: 12V/1APower consumption <1WWorking temperature-40~80°CNetwork / power interfaceRJ45 + DCWaterproof ratingIP66

1.5 Structural parametersWeight: 2850g
Size: 640x340x103 (mm)
2.2 Accessory schematic diagram
2.3 Schematic diagram after installation
2.4 Sim card installation2.4.1 Unscrew and open the gateway2.4.2 Find the SIM card holder location 2.4.3 Insert the sim card2.4.4 Close the gateway and tighten all the screws 2.5 Antenna installation2.5.1 LoRaWAN has 2 antennas of different lengths, and the short is 4G antenna, which is connected to the right side of the front of the gateway. The long is the LoRaWAN antenna, which is connected to the left side of the front of the gateway. As shown below:
2.6 Ethernet connectionPlug the network cable into the gateway line.
2.7 Adaptor connectionWE-GW-10 is typically used in complex external environments. In order to adapt to the complex application environment and improve the stability of the system, the gateway uses advanced power technology. Users can either use the standard 24VDC/2A power adapter or directly use the DC 12~36V power supply to power the gateway. If user use external power supply, the stability of the power supply must be ensured (the ripple should be less than 300mV and the instantaneous voltage does not exceed 36V), and the power of supply should be bigger than 5W. A standard 24VDC/2A power supply is recommended.

3. OperationAfter the above installation, the gateway can be powered on normally, and the user can grasp the running status of the gateway according to the indicators of the gateway.3.1 Power-onThe indicator light is red during the power-on of the gateway.

3.2 Networking connectionWhen the network is connecting, the indicator light flashes blue.

3.3 Successful networkingWhen successful to connect to network and establish with the cloud platform, the indicator light is green.