China Mt Iron Oxide H2s Absorbents Chinese Manufacturer

MT Iron Oxide H2S Absorbents Chinese Manufacturer
Iron Oxide Desulfurizer is made of iron, manganese salt and their oxide as raw material. It will be chemosynthesis processed to be active oxide first, and then be added with assistant and binder to form as columnar solid, featured of larger sulfur capacity, small resistance, high purification capacity and good water resistance, mainly applicable to the removal of H2S from semi-water gas, water gas, coke oven gas, natural gas, biogas, shift gas in petrochemical and fertilizer production, CO2 regeneration gas, and other gases.
Working principles
Fe2O3 · H2O+3H2S=Fe2S3 · H2O+3H2O
2Fe2S3 · H2O+3O2 = 2Fe2O3 · H2O+6S
Main physical and chemical parameters

Granularity (mm)Breakthrough sulfur capacity (%)Intensity (N/cm)Bulk density (g/L)Specific surface area (m2/g)Pore rate (%)φ3-5, L3-1512-20≥500.65-0.8070~8050

Operation conditions and notes
1) Airspeed: 500-1500h-1
2) Temperature: 10-80 centigrade
3) Pressure: Up to 8MPa
4) Humidity: When remove H2S, humidity is as bigger as better, the best is near to saturated steam, but strictly prohibit to bring water to the bed.
5) Operating: It should be replaced by feed gas before operating, and improve the pressure gradually, then move to the normal production.
6) When regenerate or replace desulfurizer, use inert gas to replace the flammable gas, down to the explosive limit. When regeneration, the air enters form the bottom of the tank, airspeed is 5-50h-1, at the prime of regeneration, the airspeed should be low. The temperature in the tank should be controlled below 110 centigrade, if it is above 110 centigrade, can pause air feeding, when the temperature is below 100 centigrade, then go on. It can finish regeneration when the temperature of the bed is not increase, and the content of O2 in the inlet and outlet is almost the same. When replace desulfurizer, shouldn't exhaust the desulfurizer from the discharge opening in the bottom of the tank, should be exhausted after spraying cooling for safety sake.
Management System Certification: ISO9001:2008, ISO14001:2004, OHSAS18001:2007
Company Introduction:
Shandong Mingshuo New Energy Technology Co., Ltd. Specializes in biogas project. The company is the production base of medium and large biogas equipments in China, the member of China Biogas Association, the member of China Association of Rural Energy Industry. The company is the recommended member of CCTV Website Enterprise Channel and China import and Export Commodity Website, the most complete and excellent biogas equipments manufacturers in China. Mingshuo is a professional company integrating the scientific research, technological design, production and debugging service. The company specializes in the production of desulfurizer, desulfurization equipments and biogas equipments. Such as, Mingshuo MTZ biogas dedicated desulfurizer, MT ferric oxide desulfurizer, 889 wet desulfurization catalysts, water treatment agent, MS biogas dedicated desulfurization tanks, thioniers, biogas dedicated gas-water separators, assembled tanks, gas holders, positive-negative pressure protectors, biogas dedicated flame arresters, biogas boilers, deironing magnetic separation equipments, etc.

Contact: Emma Luan